if your lookin at the radiator on the front of the car there is a plug about half way down the left hand sideif you twist and pull that will release water I'm unsure about other models but the kseries 1.4sli this plug is alos the thermostate/fan switch 2
Pls let me know the cylinder head bolt tightening sequence for toyota cressida mx83
The cylinder had bolt tightening sequence should begin by tightening the head bolts on each end of the head. Tighten the center head bolts. Work towards each end of the head, alternating back and forth.
head bolt sequence Toyota tercel
Rover 20T2N 2.0Ltr Diesel engine Cam cover torques are listed as 12 Nm. No tightening sequence is listed .
tightening sequence of what part?
hondahookup.com has manuals
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
20nm +180 degree +180 degree
bolt tightening sequence on what part?
hondahookup.com has manuals u can download with the info u need
The cylinder head torque settings are a list of parts in the torque sequence. It tells where everything is and can be found.
Check www.60degreev6.com -Kyle email@example.com
http://wiki.answers.com/Q/What_are_the_torque_settingsand_tightening_sequence_for_the_cylinder_head_bolts_on_a_kia_sedona_2.9 the cylinder head bolts on a kia sedona 2.9?"
45,65,65 ft lbs then 90 degrees.
torque specs in Nm and tightening esquence
in sequence torque bolts to 20nm, then again in sequence turn a futher 120 degrees, and again in sequence 120 degrees.
The torque settings for aluminum head are; stage 1. 15lb ft. Stage 2 you have to set the correct torque level by angular measurement, angle tighten a further 240 degrees. Cylinder head tightening sequence is important if you do not want to warp the head. Get down to your local library go to the technical section and photocopy the section from the Haynes manual
you need to get a chiltons repair manual from the library for your year car to find that out.
No such thing, just remove them. However there is a sequence to tightening them.
The Honda had bolt tightening sequence begins with the head bolts on each end of the head. Tighten the head bolts moving to the center, alternating from and to end.
Use new bolts. Apply a light coating of engine oil to the threads of the new cylinder head bolts. Install the new cylinder head bolts to the cylinder head. Tighten the cylinder head bolts to 40-60 Nm (30-44 lb-ft). The sequence is to start at the middle bolt on the intake side of the head, then move to the exaust side, then move out to the ends of the head in a criss-cross pattern. Loosen all cylinder head bolts approximately two turns, then retighten the cylinder head bolts to 60 Nm (44 lb-ft). After tightening, turn all bolts 90 degrees, in the same sequence. Complete bolt tightening by turning them an additional 90 degrees, in the same sequence.
Torque settings daewoo espero cylinder