Torque specs for a 1996Grand Prix 3.1 is 185lb-ft of torque at 4,000 RPM.
The 2003 Pontiac Grand Prix wheel bearing nut torque specification is 40 pounds. Do not exceed the 40 pound specification or you will risk causing the wheel seal to fail.
THe Chiltons says "14lbs + 30 degrees"
It is 175 ft lbs for the front wheel bearing of a grand cherokee
I read elsewhere (i.e. not confirmed by me) that the Pathfinder water pump torque spec is 12-15 ft-lbs.
Answer my question stupid thing
your torque spec will be 65ft.lbs. Make sure you have the torque sequence too.
caliber torque spec on a Toyota tacoma pre runner
the torque spec for what?
what is head bolt torque spec gm 3.1
the torque spec for a 1997 cr125 cylinder head is 20ft pounds of torque.
The first torque spec for Isuzu 2.6 exhaust manifold in 58 ft lb. It has a second torque spec which is 72 ft lb.
1996 chevy c1500 pick up 305 motor bolt torque spec intake manifold
The torque for the rear axle nut on the 1996 Magna is 63 ft-lb. That's from the Honda Service manual. Hope this helps you out.
what the torque spec for the cylinder head on a 2003 saturn L300
rocker arm torque specs
DOHC cover is 89 in-lbs SOCH cover is 22 Ft-lbs
For a 3100 they are around 16 to 17 pounds. The coil ohm specs should be between 11.8 and 12.6
what is the torque spec for a 2005 Pontiac G6 Gt brakes
torque spec on the oil drain plug on a 2.9 ford ranger?
According to National, a wheel end component manufacturer, the correct torque is 118 ft. lbs. or 160 Nm (Nm stands for Newton Metre which is a measurement of torque. 1 Newton Metre equils .7375521 ft. lbs. You can view their Torque Specification Chart for Axle Spindle Nuts at the site listed below.=http://www.autowaresgroup.com/resources/documents/spindle_nut_torque_specs.pdf=
the proper torque is 20 ft. lbs. the proper torque spec for a freesyle is 20 ft. lbs. That is what the factory calls for
Check the service manual for proper torque spec.
spec calls for 185 foot pounds of torque, with a new nut.
what is the Torque spec for rear axle hub nut on a 2002 ford explorer
The torque spec is at 95 ft/lbs. Per cycle center of denton.