For all 1992 Dodge Dakota V6 andV8 engines:
For 1992 Dodge Dakota 4 cylinder engines:
215 in. lbs
12ft lbs for transmission pan bolts
The 1996 Dodge Intrepid main bearing torque specification is 180 pounds. The main bearings should be torqued in 60 pound intervals.
the correct torque for these bolts is as follows: 96lbs
The head bolt torque for the Dodge 6 cylinder and V-8 engines is 50 ft. lbs. torque. If it is a diesel engine, the torque is 90.4 ft. lbs. Tighten the bolts by working from the center out, and alternating side to side. This prevents warping of the head.
what is the torque specifications for the intake bolts on a ford 4.2L?
13 FT. LBS or 17 N.m That is for the 42re transmission The 46RE is the same also. Good Luck.
How do I get to the flywheel bolts on a 98 dodge dakota to remove a transmission
In general starters do not have torque specifications. You will want to tighten the starter as tight as you can without breaking the starter bolts.
155 ft. lbs. for the upper control arm-to-frame bolts.
It is a mixture of both.
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
40 lbs on the water pump bolts
A C15 Caterpillar engine has dozens of torque specifications for many different engine bolts. The head bolts should be torqued at 350 pounds.
36 ft lbs and then 90 degrees
Torque specs can be found in the Haynes Auto Manual.
the longer (new bolts) are to torqued to 48lbs and the shorter ones are to be torqued to 45lbs then turn the bolts an additional 90 degrees the bolts need to be replaced with new one because they are streched when you torque them down
6 bell housing to block bolts.
The starter bolts on a 1998 Dodge Dakota require a 5/8 inch socket or wrench.
The 2005 Yamaha cylinder bolt torque specifications are 90 pounds per square inch. The cylinder bolts should be torqued at 30 pound intervals.
30 foot-pounds of torque for each of the seven bolts
I think it's 46 foot/pounds.