Chevy Blazer

What are the torque specs for a 1996 S10 Chevy Blazer intake manifold?

495051

Top Answer
User Avatar
Wiki User
2005-11-21 05:21:08
2005-11-21 05:21:08

i checked with my brother who is a a.s.e. certified mechanic. it is 11 ft-lbs be sure to chase the threads with a tap and die set, and use locktite. to much torque will ruin the gasket, and not enough will cause a manifold leak.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

It is on the back of the intake manifold.

User Avatar

start with center bolts and work your way out in a circular patternaltenating from side to side

User Avatar

That's easy you can find those in the [http://www.themotorbookstore.com/chevpic.html Repair Manaul You Have].

User Avatar

1996 chevy c1500 pick up 305 motor bolt torque spec intake manifold

User Avatar

The 350 cubic inch Chevrolet intake manifold bolts have a torque specification of Haiti pounds psi. The bolts should be torqued at 40 pound intervals.

User Avatar

Need to check the 4 corners on the intake manifold. It is common for the intake to leak engine coolant.

User Avatar

It is between the upper and lower intake manifold. The gasket is an o-ring type.

User Avatar

On the poppet bank under the upper intake manifold.

User Avatar

Need to know the year and engine size.

User Avatar

Lower intake manifold bolt 115 in/lb. Upper intake manifold bolt 18 ft/.

User Avatar

how tight do torgue specs need to be after insalling a intake gasket on a 2003 Chevy silverado

User Avatar

torque specs. on chevy sub for a 5.3L intake manifold and tighten sequence NEW ANSWER; step 1 is 44in-Lbs. then step 2 is 89in-lbs. That's it.

User Avatar

Under the upper intake manifold. The upper intake manifold would have to be removed to gain access to the bank of injector poppets (the spider).

User Avatar

On the 4.3 engine it is located under the upper intake manifold. The upper intake manifold must be removed to gain access to it.

User Avatar

depends on the engine that the truck has in it. check on autozone.com

User Avatar

how to drai torque converter on 1999 chevy blazer

User Avatar

The last one we did in our shop was a little over $600

User Avatar

It is under the upper intake manifold, attached to the bank of poppets.

User Avatar

The ERG valve is located on the front of the engine on a 1998 Chevy Blazer V6 4.3L. It is near the top bolted to the intake manifold.

User Avatar

If it is a v-6, I would say the intake manifold to head connection.

User Avatar

If your engine is a 4.3L V-6 with CPI (central point injection) it is inside the upper intake manifold. The upper intake manifold is bolted on top of the normal intake manifold. The throttle body is mounted on it and your fuel lines terminate into the center of this.

User Avatar

for a Chevy 350 enginge its 25 to 30 ft lbs. cast iron heads.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.