What are the valve cover bolts torque specs for 1993 Mercury Tracer 1.9?

If you remove the rear seat cushion you should see a cover with four bolts or screws, under that is the fuel pump.

just tighten it snuggly .it will be fine as long as there is all the bolts in it

if memory serves me, you are going to have to remove the crank pulley to get the cover off without breaking it.

89inch pounds is the torque rating for the valve cover bolts

The bolts have a number on it, what is the number? There is a general torque spec in the shop manual that will say what the torque is based on that number

Torque for valve cover bolts is 7 to 10 ft. Lbs . Tighten the bolts in a criss-cross pattern .

Tighten the valve cover retaining bolts in sequence, torque them to 71-106 inch lbs. (8-12 Nm).

35 ~ 46 Foot pounds of torque. Pressure plate bolts.

Reset button is in trunk on right wheel well cover.

The 2001 Nissan valve cover bolt torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.

what kind of car? each car has it own torque spec 2000 Chevy Cavalier

In the cylinder head (top part of motor under valve cover).

Sheet metal cover 12 to 18 ftlbs

A red button probably in the trunk or fender-well cover of a wagon. Look under a cover.

The 2001 Mitsubishi Montero Sport 3.0 liter engine valve cover torque specification is 40 pounds. You do not want to over torque the valve cover bolts, as you may ruin the valve cover gasket.

Check the specs for the vehicle you are working on (You can find them on the net if you do not have the manual) and the torque requirements will be there. Do not over torque the bolts as removing a broken valve cover bolt is a pain. Good luck.

The valve cover bolts need to be torqued to 72 to 84 IN-LBS

Valve cover is 85 in-lbs not ft-lbs

There are raised ridges oon the plastic timing cover that provide the timing marks

The torque specs on the valve cover bolts on a 1999 Hyundai accent are 71 to 89 INCH pounds or 8-10 N.m.

The 2000 Mazda 1.8 liter engine valve cover torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.

the recommendation for the differential housing cover bolts is 16 ft. lbs.

You need to remove the lower transmission inspection cover.

you have to take the timing belt cover off and timing belt to get to the water pump

Drain your oil and change your oil filter but do not refill your oil yet. undo the bolts on the valve cover that is leaking and remove the valve cover. remove the old gasket and clean the valve cover. make sure there are no cracks or anything on your valve cover, if so you may need to replace the cover. fit the new gasket on the cover and put the cover back on. now put the bolts back on the valve cover. you will want to google the torquing instructions as well as what order to put the bolts back on. if you over torque you may break your valve cover and it you put the bolts on incorrectly you may not seal your valve cover properly and will still have a leak.