Ford Explorer
Chevy Cheyenne
Saturn S-Series
Ford Explorer XLT

What are the valve cover torque specs for a 93 ford explorer 40 v6?

272829

Top Answer
User Avatar
Wiki User
2005-11-25 22:50:15
2005-11-25 22:50:15

53-70 in-lbs

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

the valve cover torque specs are 85in lbs

User Avatar

89inch pounds is the torque rating for the valve cover bolts

User Avatar

The torque specs on the valve cover bolts on a 1999 Hyundai accent are 71 to 89 INCH pounds or 8-10 N.m.

User Avatar

depends on what your wanting to torque down. Heads? Valve cover?

User Avatar

The valve cover torque specs for a 1989 Honda Accord is between 20 and 25 pounds per square inch. Proper torque is important to keep the cover in place without causing damage or leaks.

User Avatar

The 2001 Mitsubishi Montero Sport 3.0 liter engine valve cover torque specification is 40 pounds. You do not want to over torque the valve cover bolts, as you may ruin the valve cover gasket.

User Avatar

Cylinder head cover to cylinder head...torque to 25 Nm (18 ft-lb).

User Avatar

Same torque for a sparkplug should be fine. Criss cross patters should be used

User Avatar

what is the torque specs and valve lash on a 24 hp Briggs

User Avatar

54-70 lb/in NOT foot pounds... www.teamzx2.com

User Avatar

Valve cover torque spec for 4.0 SOHC is 89 in-lbs. - Haynes Repair Manual #36071. This manual is for Ford Ranger Pick-ups, 1993-2005 models, but DOES include torque specs for the 4.0L SOHC engine.

User Avatar

The valve cover on a Ford 5.0 engine has a torque of 10 foot-pounds, though this can vary between other models. If possible, locate a service manual, which will list the specs for your particular engine.

User Avatar

Check the specs for the vehicle you are working on (You can find them on the net if you do not have the manual) and the torque requirements will be there. Do not over torque the bolts as removing a broken valve cover bolt is a pain. Good luck.

User Avatar

if engine is 2.4 liter twin cam, torque is 2 steps. step 1 starts center out torque is 35 inch pnds. step 2 repeat center out 65 to 90 inch pnds. this is for valve cover pan .

User Avatar

the torque specs for valve covers on the 3.0 SOHC is 7ft/lb make sure to clean the oil and old gasket material off well and put the RTV in the corners. take great care not to roll the gasket on the rear valve cover!

User Avatar

If using RTV it is 55 in-lbs, if using a permanent gasket it is 44 in-lbs.

User Avatar

The 2001 Nissan valve cover bolt torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.

User Avatar

as far as I've known there is no torque specs for a valve cover ive been workin on Honda's since i was 15 i just have tightend them down tight an there was never any problems


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.