0
What are three general steps which are necessary for installing a network card and connecting a PC to a network?
Wiki User
∙ 14y ago
Check mechenical part, the adapter was installed prorerly and in its place. Check software part, drivers were installed properly. Try to ping the router or the desktop itslelf. It will help only in the case when the adapter was damaged.
Wiki User
∙ 15y ago
Wiki User
∙ 14y ago(1) put the NIC in the PC, and install the NIC's drivers; (2) configure the NIC using Windows, so that it has the appropriate address on the network and the correct network protocols; (3) test the NIC to verify that the PC can access resources on the network.
Add your answer:
Earn +20 pts
What are the three general steps which are necessary for installing a network card and connecting a PC to a network?
Put the NIC in the PC, and install the NIC's drivers. Configure the NIC using Windows, so that it has the appropriate addresses on the network and the correct network protocols. Test the NIC to verify that the PC can access resources on the network.
What is connecting to a network?
Network Topology decides how Devices on a Network will be interconnected. General used Topologies are BUS, RING & STAR Topologies.
When connecting to a wireless network you are given the opportunity to enter the of the network?
name of the network
What are ten safety issues surrounding installing network cables?
what are 10 safety issues surrounding installing network cables
What is the main advantage of connecting computers into network?
The main advantage of connecting computers into network is to share and control all kind of resources of the network you have created for your users.
What is network communication?
communication network is a network of connecting the people to communicate with each other.
What is the difference of installation between network version and stand-alone version of GstarCAD?
The installation program of GstarCAD network version and stand-alone version is completely the same, but to select stand-alone version or network version according to authorization methods on installing. If you install the stand-alone version when you use network lock, you can only use 30 days as installing the trial version. When you use stand-alone lock, it is not necessary to install lock drive if you use USB lock, but necessary if system (WIN98, etc.) can' t identify USB interface. Network lock is parallel lock or USB lock. Select network version when installing GstarCAD at customer end. If network lock installs normally, setting is not necessary at customer end. If there are two or more network locks in one network, it is better to setup the locks in different computer and then set the name and IP address of the computer onto which set the network lock at customers' end.
Who writes guidelines for installing network cables in commercial buildings?
The guidelines for installing network cables in commercial buildings is written byTIA/EIA.
What is a cross-connecting?
Is a piece of circuit - switched network equipment used in telecommunications network.
What is meant b networking?
It means connecting different computers and other equipment into a network, so that they can share data and resources.It means connecting different computers and other equipment into a network, so that they can share data and resources.It means connecting different computers and other equipment into a network, so that they can share data and resources.It means connecting different computers and other equipment into a network, so that they can share data and resources.
Connecting one computer to another creates a?
network
What are other methods of connecting your computer to the internet?
using a dial-up network or a broadband network
