answersLogoWhite

0


Best Answer

you need to take off both caliper bolts and remove the caliper from the carriage... most Mazda calipers will not pivot...

User Avatar

Wiki User

โˆ™ 2011-09-13 21:56:23
This answer is:
User Avatar
Study guides

Can slotted or drilled rotors be machined in a brake lathe

โžก๏ธ
See all cards
3.0
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
2 Reviews

Add your answer:

Earn +20 pts
Q: What bolt do you take off to change front brake pads on 1990 Mazda 626?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the brake pads on a 1990 Oldsmobile cutlass ciera?

FRONT OR REAR ?


Power brake 1990 Mazda 929 fails?

929 1990 Mazda power brakes fails


Where do you add brake fluid in a 1990 Mazda protege?

To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.


How do you remove the front brake disc on your 1990 Mazda MX-6?

You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.


Where is the tns relay on a 90 Mazda roadster?

The TNS relay on a 1990 Mazda Roadster is located on the drivers side of the car. It will be right beside the brake.


What tools do you need to change the front and rear brake pads on a 1995 Buick Regal?

On my 1990 Buick Regal, I need an 18mm wrench , a 10mm wrench, screwdriver, jack, and a can of brake cleaner


Does a 1990 Mazda 626 have a front catalytic converter?

Not sure but a 1991 model does, so it stands to reason that a 1990 would.


Location of flasher on a 90 Mazda MVP?

The flasher on a 1990 Mazda MVP is located under the dash on the driver's side. It is just above and to the left of the brake pedal.


How do you change the third brake light on a Mazda Miata?

Open the trunk.Look up behind the 3rd brake light, you'll see a small bulb harness in the middle.Lightly twist it counter-clockwise, and the harness will come out.Pull out the old bulb.Insert new bulb.These steps are good for all Mazda Miata years 1990-2005.


Where is the clutch master cylinder and slave clylinder on a 1990 Mazda rx7?

master cylinder is the one where the brake fluid is stored and its in the top left hand side of your car right in front of the steering wheel in the engine conpartment


Where is the horn relay location in 1990 Mazda 323 station wagon?

The 1990 Mazda 323 horn relay switch can be found on the front drivers side quarter panel. The relay switch will be on the inside of the quarter panel.


Can you replace a 1990 Mazda b2600i engine with a 1986 Mazda b2200 engine?

yes you can its a straight swap you don't even have to change engine mounts

People also asked