Could be several things, from a leaking vacuum hose (unlikely if it is stalling occasionally), worn spark plugs, (which would also cause hard starting, hesitation). Most likely it is the idle sensor, which is located on the intake close to where the air filter tube goes into the engine. It is a small piece, with a wire attached to it. It most likely would follow with a check engine light, if equipped, that would come on after the stall. It's not an expensive piece, and not hard to install.
Need to replace the ingnetion module in the distributor.
No, they are different
how to replace the slave cylinder on a 1993 jeep wrangler
The correct factory tire size for a 1993 Jeep Wrangler is 215/75R15.
Check for leaks in the intake manifold or a poor fuel pressure situation.
It is not adjustable.
about 16 mpg
The gas tank on a 1993 Jeep Wrangler is under the very rear of the vehicle. It is just in front of the rear bumper.
A 1993 Jeep Wrangler needs approximately 6 quarts of oil for an oil change.
How to change a clutch and master cylinder on a 93 jeep wrangler
no it will not, the frame is slightly smaller in the earlier jeeps
Yes, I have a 1993 6 cylinder with abs...probably an option.
Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5
because everyone elses 1993 ford tempos stall when they idle. learn to drive with one foot on the gas and one on the brake like I do in my '93 tempo. keep the RPM at 1000 and it won't stall out.
no, they are entirely different vehicles
They are both YJ's so it should be a good fit.
Yes, they should be the same motor.
Replace your thermostat.
In the fuel tank