Ford Freestyle
Classic 1964-1978 Ford Mustangs
Late Model 1979-New Ford Mustangs

What causes an airbag blink code of 10 on a 1991 Ford Mustang?

234

Top Answer
User Avatar
Wiki User
2009-03-29 22:07:54
2009-03-29 22:07:54

look under the driver seat, remove the two french frys , the penny and the dime next to the quarter. then check the wire connection there. i had the problem on a explorer once. then clear the code and see if it comes back on.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

do 1991 honda accords have airbags?

User Avatar

That's the OD warning light, Check wiring, relay, Solenoid, and switch

User Avatar

I had a 1991 Ford Mustang 5.0 L - LX - automatic , and it had 2.73 's

User Avatar

In a 1991 Ford Mustang : The 5.0 liter V8 is rated at ( 225 horsepower from the factory )

User Avatar

It indicates a problem with the airbag. When it's lit the airbag will not deploy.

User Avatar

airbag sensor and iat sensor are not the same thing... wiki

User Avatar

There is no such thing as a 1991 Mustang Cobra, SVT did not start producing the Cobra until 1993.

User Avatar

where is the intake air charge temp. sensor on a 1991 ford 5.0 coupe mustang

User Avatar

Bucky O'Hare and the Toad Wars - 1991 On the Blink 1-5 was released on: USA: 6 October 1991

User Avatar

airbag light. if it turns on it means your airbag will not deploy.

User Avatar

No , the 5.0 liter High Output V8 engine in a 1991 Ford Mustang GT has a timing CHAIN

User Avatar

No 1991-93 Mustangs use a different frame for the top.

User Avatar

There are absolutely no body parts that interchange with a 1991 mustang and 1991 cougar. The mustang is a fox body chassis and the cougar is on the mn12 chassis. The older cougars I believe pre 1988 were structurally similar to a mustang, by this i mean engine bays very similar and rear ends interchangeable. As far as the bodies they did not have interchangeable parts.

User Avatar

Yes the front seats from a 89 mustang v6 will fit in a 91 mustang, the tracks are the same.

User Avatar

I need how to wire relay for 1991 ford mustang.

User Avatar

The 1991 Ford Mustang does not have an OBDII port, because OBDII was not standardized in the United States until 1996.

User Avatar

Try: www.veryuseful.com/mustang/tech/engine#Diagrams

User Avatar

yes, the 5.0 (302) will fit in a 73' for sure.

User Avatar

On my ( 1991 ) Ford Mustang 5.0 liter the spark plug gap was ( .054 inch ) What year of Ford Mustang ?

User Avatar

Go to: www.veryuseful.com/mustang/tech/engine#Diagrams


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.