answersLogoWhite

0


Best Answer

2 reasons for the system to cut out, low pressure, and high pressure.

I am thinking you are experiencing low pressure and need to recharge your system.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What causes the air conditioning to go out in a 1998 Jeep Wrangler after 10 minutes of operation?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What causes the coolant to come out of the radiator cap on a 2002 Saturn LS when the air conditioning is working?

Check the following............................. 1. Cooling fan operation. 2. Radiator cap. 3. Thermostat.


What causes air conditioning and heater not to work?

No electricity


What causes wet floorboards in Jeep Wrangler?

There are several possible causes here: A leaky windshield seal, a leaky top seal, or missing floor plugs. The most likely answer, however, is that it's a Wrangler.


What causes the air conditioning in my house to smell like bunt rubber?

poop


What causes a Jeep Wrangler to shake after 50mph?

Sounds like wheel balance, but check the steering dampner.


Which chemical uses in refrigeration and air-conditioning system is responsible for destruction of ozone layer in the atmosphere?

CFC is used in air conditioning systems. It causes ozone depletion.


What causes leaks in air conditioning units?

You might be thinking of condensation, the transition of a gas into a liquid.


What causes a rattle when shifting from 3rd to 4th in a jeep wrangler 2000 manual?

Heat shield on your exhaust system?


Why does air conditioning use more fuel?

Because the air conditioning compressor, is run from a pulley off of the engine. This puts an additional load on the engine, which causes more fuel to be used.


What causes that freon is not charged in central home air conditioning system?

Usually there is a leak somewhere in the system.


What is the operation of pump in hydraulic jack?

The operation of the pump in a hydraulic jack is to generate pressure. This causes the jack to rise and lift as needed.


What causes 97 wrangler to cut out when going from reverse to first and second gear?

a bad driver?? Seriously, i could be the ECU