answersLogoWhite

0

What controls the knock and o2 sensors in a 1988 cavalier?

Updated: 8/20/2019
User Avatar

Wiki User

10y ago

Best Answer

They are not controlled, but the engine computer reads their out put signals.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What controls the knock and o2 sensors in a 1988 cavalier?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a faulty oxygen sensors cause a truck to run bad on a 1988 Chevy 2500?

yes it can. also check knock sensor and the wire going to it


Does a 1988 Chevy s-10 have sensors?

Yes, it has many sensors.


Does the z24 cavalier have a v6?

Yes, I have a 1988 and 1989 Chevy Cavalier Z24 and they both have the 2.8L V6


Where is the flasher located on a 1988 Chevy Cavalier?

1988 chevy cavalier flasher take ash tray and bracket out look up and lift you can see it if not you can put your hand up in to lift and find it.


Where is the fuel pump found on a 1988 z24 cavalier?

in the fuel tank


Which direction does the crank turn on a 1988 chevy cavalier 2.0?

CW.


Where are the Oxygen sensors are on a 1988 Pontiac Bonneville SSE?

Oxygen sensors are located in the exhaust manifolds & in the exhaust pipes on most vehicles


How many oxygen sensors on 1988 Chevy silverado have 350 motor?

It has 1


Where is the convertible top relay switch located on a 1988 Cavalier Z24?

The right person to ask would be either someone who owns a 1988 Chevrolet Cavalier or a mechanic at a Chevrolet dealership. This question is too complicated to answer in a simple manner.


Where is the crank position sensor on a 1988 Cavalier?

check on the back of the motor above the transmission


What is the horsepower of a 1988 Chevy Cavalier Z24?

The 2.8 litre (2800cc,173 cu.in.) 60 degree v6 in a 1988 Chevrolet Cavalier z-24 was factory rated at 130 HP, torque came in at 160 ft. lbs.


How do you replace the thermostat located on a 1988 Chevy Cavalier 4 cylinder automatic?

Remove the water supply hose from your 1988 Chevy Cavalier thermostat housing. Remove the thermostat housing bolts. Lift the old thermostat out and drop in the new thermostat.