answersLogoWhite

0


Best Answer

check your fuel inertia switch. it may have came unplugged. located on passenger side under dash.

User Avatar

Wiki User

โˆ™ 2007-03-11 16:00:43
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: What could the problem be with a 1993 Ranger who's motor died after hitting a big bump?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Torques motor 4.0 Ford Ranger?

Torques motor 4.0 ford ranger?


How do you replace a motor mount on 2002 Ford Ranger?

how do you change motor mount on 2002 ford ranger


How do you remove a 1999 Ranger transfer case shift motor?

How to peplace A RANGER transfer case SHIFT MOTOR


Can you put a 2001 3.0 ranger motor in a 2000 ranger?

not really


Will a 1999 Ford Ranger 4x4 motor interchange with a 1998 Ford Ranger?

as long as it is the same size motor it should


What kind of changes need to be done with a motor swap for a 99 ford ranger flexfuel Can you use a nonflexfuel motor What needs to be changed?

I believe the only requirement would be that the motor be that same displacement as the Flex engine. There could be a problem with the ECU (PCM, computer) So you may have to use a non flex ECM.


The rear wiper on my expedition doesn't work what could be the problem?

could be the switch the relay the fuse or the motor


Will a 390ci motor fit in a ford ranger?

No.


What would cause a 95 ranger to jump when accelerating?

Check for a broken motor mount or transmission could be going bad.


Where is blower motor resistor for 2002 ford ranger?

It is usually ( at least on a 2000 Ranger) locted on the blower motor housing in the engine compartment.


1999 Ford Ranger Air Conditioning fan speed switch only blows air on max ac Is this a switch or fan motor problem?

If you are saying the blower motor only works on the high speed setting, then the problem is a bad HVAC Resistor Pack.


If the blower motor quits working after an extended period of time and then afterwards start working again work could the problem be the blower motor resistor?

Could have just overheated

People also asked