What damage can a leaky intake manifold cause in a 1995 Buick LeSabre?

The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.

replace the water heater inlet pipe on the intake manifold on a 3800

You did not mention if it was the intake to the cylinder head bolts (1993 buick lesabre 96 in-lbs)..... or ..... the intake upper to lower bolts ( 1993 buick 132 in -lbs) but i hope you will know wich you are looking at since there is a large difference in torqe.

The IAT sensor is located on the intake manifold air cleaning housing or air duct.

Most likely a cracked intake manifold.

Most EGR valves are located on the intake manifold with a vacuum line attached. Most are held on with two bolts.

Manifold Absolute Pressure/Barometric Pressure Sensor

The 1997 Buick LeSabre mass airflow sensor is located on the outside of the air intake housing. The sensor can be found on the right hand side of the air intake housing.

Manifold ait temperature sensor circuit. Year and model?

The lower intake manifold to cylinder head torque specification is 132 inch pounds. The upper plastic intake plenum to lower intake should be done in three steps 22 inch pounds, 44 inch pounds and thirdly 89 inch pounds. Be sure to follow the appropriate tightening sequence diagram.

Its at the rear of the engine in the intake manifold. Take the 2 bolts off that hold it and clean all of the carbon before installing the new one.

The Coolant Temperature Sensor on a 1993 & 1994 Buick LeSabre is located on driver's side of the car under the throttle body, It is screwed into the lower intake manifold. You cannot see it without first removing the throttle body since it is hidden under it. An electronic plug is clipped to the the end of the CTS.

Passenger side of black plastic intake plenum.

Leaking from? Hose Water pump Intake gasket

Where is the thermostat located on a 1987 Buick LeSabre?

where is the ecm on a 2000 buick lesabre

It should be located on the intake manifold by the distibutorless ignition module. On my 92 Lesabre it is located near the plugs at the back of the motor. On my 94 LeSabre it is located on the front/driver's side of the engine. There is a 4-wire connector on the top and it is mounted by two bolts on a flange. About 2" in diameter, 4" high.

directly on top of the throttle body intake

Is there a parts interchangeability list for buick lesabre

where do the thermostat go in my 93 buick lesabre

Where does the camsensor go on a 1997 buick lesabre

1995 Buick LeSabre how do i reset my radio

18436572, should be stamped on factory intake manifold

The intake manifold, head, and exhaust manifold must be removed to gain access to the gasket.

what can cause a 2002 buick lesabre to not crank