answersLogoWhite

0


Best Answer

Usually you just have to replace the electric panel and maybe the electric meter and entrance cable. It would be unusual, but the power company may want to replace the cable from the local transformer to your house.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What do they replace when upgrading from 60 amp to 100amp?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will a 2 pole 60 amp ITE Gould or Westinghouse breaker replace a 2 pole 60 amp T and B unit?

If the breaker will snap on the bus bar, yes.


Can you put a 60 amp fuse in a 60 amp disconnect?

yes


Can work wire for 100 amps use for 60 amps circuit?

If you have 100 amp wire, you can use it for a 60 amp circuit, or for any circuit of 100 amps or less. But if you have a 60 amp circuit, 60 amp wire is thinner and cheaper than 100 amp wire.


Can you feed a 60 amp sub panel from another 60 amp sub panel?

Yes


How do you convert amp hours to amp minutes?

Divide by 60.


What size breaker is used for a 5 ton 34 amp minimum 60 amp maximum?

60 amp using AWG # 6 copper for branch circuits.


Can you use a 60 amp breaker with a 50 amp overcurrent device?

A 50 amp breaker is an overcurent device.


What is the Chicago required breaker amp for an apartment?

Most apartments have a 60 amp panel for their electrical distribution.


What is the largest sub panel you can install off from a 60 amp main panel fed by 100 amp service?

If what you state in this question is accurate this is an illegal installation. A 100 amp service can not have any equipment connected to it less that that of the service size. The 60 amp main panel must be a 100 amp panel to be a legal installation.


What is wrong with a 1993 ford f150 no brakes and abs light on?

Get out your owner guide, page 60 talks about abs warning lights.Go to page 312 locate fuse #13 a 15 amp and fuse #15 a 20 amp replace these fuses and life is good again.


Can you put a 50 amp beaker in a 60 amp panel?

I've never heard of a 50 amp b-e-a-k-e-r. You can put a 50 amp b-r- e-a-k-e-r in a 60 amp panel; but you can only have an additional 10 amp breaker along with it. You may need to consider adding another larger panel or a separate 50 amp breaker box.


Does anyone make a 100 amp GFCI breaker?

Not that I know of. The largest GFCI breaker I have seen is a 60 amp.