answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-09-13 10:22:49

replace the key switch hope this works for you

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Check under the dashboard, to the left of the steering column.



look under vehicle along frame, follow line from fuel tank


my factory radio does not stay programed when car cuts off and i tried three different ones



remove the right front tire should be directly behind to yhe left of the airconditioning commpresser this is a Pontiac 3800.



on a 93 Pontiac Bonneville you would remove the passenger side front tire. there may be a plastic cover that just pulls off. look to your left,back and up a little bit you should see the wires that connect to your cam sensor. theres your cam sensor. 91 Bonneville is probably the same.


Wiggle the steering wheel back and forth and run the transmission shifter down then put it firmly back into park.


The tensioner belt is interchangable as both vehicles use the same engine, the GM 3800


does you're car lose power as well? you may have a short somewhere in the connections or a corroded wire(s)


I work at Napa Auto Parts, and we only have one belt listed. Part # 25061025


from my understanding that code is just a factory assessed code.doesnt really mean to much from my understanding that code is just a factory assessed code.doesnt really mean to much


How do you replace starter on2.3 cy 1991 pontiac grand am


It is listed in the 1991 Pontiac Firebird Operations Manual


It is located in the fuse box under the plastic cover at the bottom of the dash. Make sure you don't have any burned out bulbs, as sometimes that will cause the others not to flash.


I believe you want to drain the coolant, remove the top hose at the thermostat housing, remove the housing, replace the stat and gasket, reassemble fill with coolant and bleed the system.


Where is the rear washer fluid reservoir located on a 1991 Pontiac Transport


the VATS chip wiring on the back of the ingnition switch is bad, can be bypassed by a decent mechanic


It came from the factory with R12 Freon. It may have been converted to R134a. If so there should be a sticker near the compressor. If it has not been converted, I suggest you do so, as the price of Freon is prohibitive.


In a 1991 Pontiac Grand Am : According to my Chilton's Auto Repair Manual : ( 13.6 U.S. gallons )



It has the 3800 V6 used from 1988-1991, so it will have 165 horsepower. Don't be fooled though, these cars are still fast, I've driven one. If you were wondering, it has 210 lb/ft of torque. =)



Probably the control unit mounted underneath the relays by the firewall. Get a used one somewhere, but get a new blower (parts store item) to go with it. That might save you from having to buy an other controller.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.