Cars & Vehicles
Fuel Pumps
Chevy S-10
Ford Expedition XLT

What do you have to do to change a fuel pump on a ford 1993 probe the engine is a 2.0?

123

Top Answer
User Avatar
Wiki User
Answered
2007-04-15 18:12:05
2007-04-15 18:12:05

Remove fuel tank Remove fuel tank

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


its a Mazda engine . ( DOHC 4cyl. 16 valve 2.0l ) For the probe 1993


diagram of starter in a 1993 ford probe


Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.


The 1993 Ford Probe oil filter can be found on the left side of the engine. The oil filter will be near the oil pan. The oil filter is easily seen from the bottom of the engine looking up.


Which engine? 2.0L = 3.7 quarts with filter 2.5L = 4.2 quarts with filter


It is important to check and maintain the fluid levels while owning a car. The transmission dipstick of a 1993 Ford Probe is located behind the engine, to close to the firewall and it has a yellow cap.


Japanese Motor that is frequently engine swapped into a Ford Probe.


ford probe gt rims are 7 inch


THERE WAS NO FORD PROBE IN MODEL YEAR 1985


Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder


On the passenger side of the engine about half way down inside the engine compartment toward the front of the engine compartment


stock enginestock engine in 1994 ford probe GT is a Mazda 2.5L 24 valve V6.


no, the 89-92 engine/transmissions are different from the 93-97 ford probe.


The ford probe gt does not have a block heater block heaters are normally on a desiel Engine


Yes , according to the Gates website the 2.0 liter 4 cylinder in a 1996 Ford Probe IS an interference engine


Follow the top radiator hose down to the water outlet on the engine; it is in the water outlet. Mark


The nosiey engine in ford 1990 how can we overcome it?


The transaxle is the transmission on a front wheel drive car . It's bolted to the rear of the engine ( in your case completely within the engine compartment )


Yes , according to the Gates website ( they make timing belts etcetera ) the 2.0 liter four cylinder engine in a 1996 Ford Probe ( is an interference engine )


how to i change a clutch in a 1993 ford ranger



it is located inside the fuel tank


---- ---- == == ---- == == ---- == == ---- == == ---- ---- == == ---- == == == == == == == == == == == == == == == == ----


Follow the top radiator hose down to the water outlet on the engine; it is in the water outlet.


the ford probe of the same years have the exact same engine



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.