answersLogoWhite
Power Steering
Mercury Villager

What do you look for if your power steering went out in a 1993 Mercury Villager?

171819

Top Answer
User Avatar
Wiki User
2008-05-21 23:07:41
2008-05-21 23:07:41

step 1 check power steering fluid level, 2 look for obvious leaks before starting, 3 make sure cap is replaced from step 1, 4 start car look for dripping or spraying fluid. if no leaks found, belt not broken, most likely pump or assist cylinder is bad, seek professional help.

1

Related Questions

User Avatar

Mercury Villager was created in 1993.

User Avatar

the unit is under the steering column.actually its stuck on the steering column and its a black plug

User Avatar

It would help if you could say what the symptoms are.

User Avatar

No, the 3.0 V6 in a 1993 Mercury Villager is NOT and interference engine.

User Avatar

You mean the OBDII connector, I assume. Under the dash to the right of the steering column.

User Avatar

There are ( 2 EXHAUST MANIFOLDS ) on your 1993 Mercury Villager 3.0 liter V6 engine

User Avatar

the elictronic control sinsor at on a 93 mercury villager

User Avatar

The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.

User Avatar

Yes, the 1993 Mercury Villager was a 1992 Nissan Quest. The last year Nissan used a Carburetor on a Quest. Fuel injection system replaced the carburetor in 1993.

User Avatar

According to one of Ford's websites : The spark plug gap for a 1993 Mercury Villager , 3.0 V6 is : ( .032 inch )

User Avatar

The 1993 Mercury Villager takes 22" replacement windshield wiper blades on both sides front.

User Avatar

The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.

User Avatar

According to fordparts.com the spark plug gap is ( .032 inch ) on a 1993 Mercury Villager with the 3.0 liter V6

User Avatar

Timing is set by the PCM and is not adjustable.

User Avatar

There is no need to do this normally.

User Avatar

According to one of Fords websites : For a 1993 Mercury Villager , 3.0 liter V6 engine : ( the spark plugs are gapped at .032 inch )

User Avatar

I was looking at one of Fords websites and it shows for the 3.0 liter V6 engine in a 1993 Mercury Villager : The spark plugs are gapped at ( .032 inch )

User Avatar

No , according to the Gates website ( they make timing belts etc. ) the 3.0 liter V6 in a 1993 Mercury Villager ( is an interference engine )

User Avatar

There are a couple of reasons why a 1993 Mercury Villager is hard to shift. One reason could be a gear shift cable. Another reason could be low transmission fluid.

User Avatar

It is a very easy one. 1.2.3.4.5.6.

User Avatar

Follow the instructions on Youtube.

User Avatar

Timing is set by the PCM and is not adjustable.

User Avatar

It's mounted on the throttle body.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.