I am getting that beep with an f as well. Would love to know the answer too. :0(
commuication error between ccu and mcu
What does f 70 mean on a whirlpool duet steam model wfw9550wl00
it means your washers broken
door latch
What does LF on cabrio washer mean
oe code means Original Equipment Code
Whirlpool Duet front-load washer F02 usually means it is taking over 8 minutes for the washer to sense that the rinse or wash water has drained, which either means that the drain/filter is clogged or the pressure switch/tube is clogged (causing both the washer to over-fill with water and not sensing that water has drained). To clear out the drain/filter, tilt the washer backwards a little for easier to the kick-plate and support the front bottom with a wood block or similar, remove the front kick-plate's (3) retaining screws and swing the kick-plate up out of the way. The filter drain is behind the white knob in the center, be prepared with something to catch any remaining water and lots of towels to soak up any spills, and turn the knob counter-clockwise to remove the filter.
E1 or E2 Thermistor Failure The dryer will not operate if the exhaust temperature drops below 18 degrees F. or exceeds 250 degrees F. When the thermistor circuit is open (>50K ohms), the error code E1 flashes in the display. When the thermistor circuit is shorted (<500 ohms), the error code E2 flashes in the display. Normal thermistor resistance values: 60 degrees F. - 15.3K ohms. 70 degrees F. - 11.9K ohms. 80 degrees F. - 9.2K ohms.
what does f70 code mean on a duet model wed9600tao dryer
In my case, it meant an $815 repair for a three year old $900 washing machine! The Service Tech said both the inner and outer tubs needed to be replaced. Whirlpool would not do a thing to help me! They do not stand behind their products beyond the one year warranty.
fake
it is saying that the motor control unit isn't functioning properly. this could be the MCU itself or the wires to the motor or the pressure (water level) switch. it also could be the motor or the pressure switch itself failing.