It is used to vary the voltage/current flow in a circuit.
It controls the circuit example in a sound circuit the volume knob would be the resistor
It is here at this website. www.mosfetdiagrams.co.uk/varibles
If you have a light switch where you can brightener it or dim it that is a VARIABLE RESISTOR.
if not disconnected you will measure the resistance of the circuit in parallel with the resistor.
When we want to regulate somthing ;we use variable resistors for example :volume control in radios and volume in headset. Also , the variable resistors can forms a potential devider in which the overall resistance between the two end points remain the same,but the ratio of the two resistors in the legs changes.so the variable resistor is affectively a potential divider. Also, the variable resistor can forms a potential divider in which the overall resistance between the two end points remains the same, but the ratio of the two resistors in the legs changes. So, the variable resistor is effectively a potential divider.
Variable resistor. The value of the variable resistor can be changed at any given moment.
how connect a variable resistor to circuit
A variable resistor usually has three terminals, one of which is connected to the 'wiper' by which means its resistance is measured. By using all three terminals, we can control the potential difference in a circuit. When used in this way, we call the variable resistor a 'potentiometer'. By using two of the three terminals, one of which must be connected to the variable wiper, we can control the current passing through circuit. When used in this way, we call the variable resistor a 'rheostat'.
It is here at this website. www.mosfetdiagrams.co.uk/varibles
There isn't anything "scientific" about this simple series circuit. If you've got a variable resistor (a potentiometer) and a diode in series, you have a simple series circuit with the two components in it.
A variable resistor usually has three terminals, one of which is connected to the 'wiper' by which means its resistance is measured. By using all three terminals, we can control the potential difference in a circuit. When used in this way, we call the variable resistor a 'potentiometer'. By using two of the three terminals, one of which must be connected to the variable wiper, we can control the current passing through circuit. When used in this way, we call the variable resistor a 'rheostat'.
Normally if a resistor fails they will either increase in value or open up at all (open circuit).
Toasters and lightbulbs.AnswerA resistor is an circuit component. So, while toasters and light bulbs have resistance, they are not resistors!
You change a variable resistor in the the tuning circuit. The value of the resistor dictates the frequency that the radio is receiving.
how do test a variable resistor
If the DC voltage of 120 volts is feeding series circuit consisting of 2-ohm, 6-ohm, and 8-ohm regular resistors, the variable resistor for line ammeter to indicate 1.5 amp, the variable resistor must be fixed before the amp.
what does a resistor in an ampliflyer circuit
Of course. A good voltmeter can be applied across anything, since its impedance is high and its presence has no effect on the operation of the circuit. When it's connected across a variable resistor, the voltmeter most likely reveals a changing voltage as the resistor is varied.