Emissions and Exhaust Systems
Ford Focus
Honda Prelude
Air Filters and Intake Manifolds

What does an exhaust manifold gasket look like for a 1986 Honda Prelude?

242526

Top Answer
User Avatar
Wiki User
Answered
2009-10-04 10:39:20
2009-10-04 10:39:20

Are some of these questions for real ? (a fair question for novice) or are site owners after free consultancy level & cost answers to further shareholders maximum yield ?

check with oem supplier

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.

The gasket is between the head and the manifold and simply remove the bolts and replace the gasket after cleaning it real good.

On the Prelude there are 2 O2 Sensors. They are on the exhaust manifold on the front of the engine. You will need to remove part of the plastic air intake in order to reach them.

How much is it to replace thehead gasket on a honda accord 1998?

The 1995 Honda Odyssey exhaust manifold bolt torque specification is 45 pounds. The exhaust manifold bolts should be torqued in 15 pound intervals.

it is in the exhaust manifold,or exhaust pipe...

Os sensors are always in the exhaust. Look either in the exhaust manifold or right after the exhaust manifold. HTH

Are you trying to remove the exhaust manifold,the muffler,or just the line running from the manifold connection to the muffler?

That means your car overheated and you blew a head gasket. It happened to my 1995 prelude.

On the back of the block, below the intake manifold.

Tail light rubber gasket is worn out. $15 from dealer.

The IAT sensor on the 1993 Honda Prelude is located to the right of the intake manifold as you face the engine compartment. It is connected with red and green wiring.

You will need the intake and exhaust manifold gaskets. I would also install new head bolts.

full exhaust and anything else to help air flow

It is a major repair that requires removing intake and exhaust manifold. Then removal of the head. Requires skill, knowledge, and the proper tools.

After the exhaust manifold but before the catalytic converter on the exhaust tube.

What are the torque specs for a 2001 Honda Passport head gasket

They are typically on the exhaust manifold.

in the catalyc converter... exhaust manifold

The O2 sensor on a Honda Prelude is found on the exhaust pipes of the vehicle. They are located near the catalytic converter which is place on the underside of the chassis.

Honda Prelude was created in 1978.

Yes you can I have 1988 Honda prelude with the 2.0L in it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.