answersLogoWhite

0


Best Answer

it could be the odb-1 testor plug. that is the computer diagonistic plug. It is hard to say without seeing the engine compartment. hope it helps. duboff.

User Avatar

Wiki User

โˆ™ 2006-09-27 19:27:30
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: What does the 3 inch cable with a 4-pin connector plug into in the engine of a 1992 Cressida Does it have to do with the transmission or air conditioner?
Write your answer...
Submit
Related questions

How do you replace the transmission fluid in a 1990 Toyota Cressida with a 22r Engine?

Are you sure of the engine size? Should be 7mge inline six cyl. 22r wasn't offered in a 1990 cressida.


I need a transmission for a 1984 cressida Toyota?

I have a 1985 cressida with a good transmission but a blown engine sitting in my hard. I live in Pensacola, FL. Call me at 850 432 3011 or email me at imacountryboy@cox.net ken


What Cressida engine will fit to a Toyota pickup model1998?

What Cressida engine will fit to a Toyota pickup model19


Where is the starter on a 1984 cressida?

Seek around the flywheel, The Flywheel is between engine and transmission. The starter is probably under the intake like the 7MGE.


1990 Toyota Cressida spark plug sequence on engine?

how the sequence of spark plugs goes on the engine of 1990 Toyota cressida


Where is the low pressure connector to recharge the air conditioner on a 2000 Chevy venture?

Low pressure connector is at the front of engine below front exhaust manifold behind the electric fan for the rad....


Changed the engine head in 1999 Chevy Cavalier and the ETS and check engine lights are on and at low speeds the transmission in jumpy?

Does the speedometer work? Sounds like the electrical connector from the transmission to the PCM is either not plugged in correctly or at all.


Does a 1988 Toyota cressida have a carburetor?

No, its fuel injected engine


Check engine light 1991 Toyota Cressida?

If the check engine light is on for your 1991 Toyota Cressida, that makes that some repairs need to be made to the engine. Taking the car to a certified mechanic to perform a diagnostic test can confirm if there is any issues with the engine.


What is the timing specification on a 1985 Toyota Cressida inline 6 with a 2.8 engine and how do you get it to pass the smog inspection when it states ignition timing B15?

It is 8-10 degree before top dead center with engine warmed to operating temp., RPM's at the proper range and the check engine connector jumped at TE1 and E1.


Where is the turbin speed sensor on a 2004 Mazda 6 with a 2.3 engine?

On top of the transmission two wire connector, one bolt holds it in place, right below the transmission mount/ battery tray.


Where is the carburetor located in a 1986 cressida?

Top of engine under air cleaner


Air conditioner 1998 riviera?

The 1998 Buick Riviera air conditioner compressor is located in the engine compartment. The air conditioner compressor will be on the left-hand side of the engine.


What is flywheel what is connector between the engine and transmitter in Chrysler concord 94?

Answer The flywheel is connected to the crank shaft on the engine. It has teeth on it that the starter connects to to start the engine when the starter gear is energized. After the flywheel and before the transmission is the torque convertor. This is what pressurizes the transmission so that is it shifts into and between gears as the car is running. Good luck.


Where do you add transmission fluid to a diesel engine?

to the transmission, not the engine


Where is the oil pan on the Chrysler Pacifica 2005?

On the bottom of the engine or transmission.On the bottom of the engine or transmission.


How do you change a crankshaft sensor on a 1996 Plymouth Voyager?

The crankshaft positioning sensor is located between the engine and the transmission about one third way down looking from inside top of engine. It is not easy to find. You are looking for a connector wire with the sensor, it is bolted onto the transmission with a 10MM bolt.


Where is the starter on a 87 cressida?

Usually the starter is located on the lower rear of the engine block.


Where is the diagnostic connector for 1994 Honda accord lx?

The 16 pin scan tool connector is on the driver side behind the panel under the steering wheel. A 2-pin connector is located behind the glovebox on the passenger side. This can be used with a single jumper wire, hook it up and count the flashes of the "check engine" light, or count the flashes of the "D" light in the transmission selector to diagnose electronically controlled transmission problems. A Honda factory service manual is available online for less than $20, a good deal as there are dozens of engine and transmission codes possible to diagnose this way.


Where is the torque converter located on a 2000 dodge neon?

Between the engine and transmission.Between the engine and transmission.


Where is the transmission located on a 1998 mystique Does the engine need to come out to change the transmission?

the transmission is located on the driver's side of the engine and yes the engine has to be removed to change the transmission


Is diesel fuel conditioner good or bad for your engine?

Using a Diesel fuel conditioner would be good for your engine and would not be bad at all.


Cressida 1989-22R-what should be the fuel consumption?

Standard 22R engine will give a mixed result of 12.5L/100km. I would say less when fitted to your Cressida.


What horsepower a Toyota 22R engine have?

The Cressida had a 2.4-litre22Rengine producing 108 horsepower


What could cause a 1988 Pontiac Grand Prix transmission to stall when hitting water?

The cause is most likely electrical, with a possible chaffed wire, loose connector connection or loose ground wire leading to the engine, transmission or elsewhere.