Riverside Arms
Math and Arithmetic
Urban Slang
Prime Numbers

What does the four digit number stamped on the lower leftside mean?

444546

Top Answer
User Avatar
Wiki User
2006-10-30 04:59:11
2006-10-30 04:59:11

I'm guessing this gun was manufactured prior to serial numbers being required by law and at some point afterward was turned in for repair work and was given this number so that it could be taken in an repaired. a batch number used for inventory control within the factory. a model number (is it perhaps 5000 or 5100?). a part number a serial number (unlikely on a Riverside gun). or even an ID assigned by a previous owner.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You find it as a 17 digit number stamped into the frame on the left lower frame rail.

User Avatar

Yamaha places its VIN on the left hand side on the lower part of the frame by the footpad. There should be 17 digit code stamped into the frame.

User Avatar

1.11 ============================= .111 is lower yet, but neither one meets the usual definition of 3-digit number. By the usual definition, 100 is the smallest 3-digit or 3 figure number.

User Avatar

Serial number is stamped on the lower tang of the receiver. It is covered by the lever. Move the lever to see it.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the tens place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the ones place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

Most F&Ws that HAD a serial number had it stamped on the butt- and stamped on the rear of the cylinder. LEGALLY, the one on the butt is the serial number. Many older guns did not have serial numbers, especially lower cost guns.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the hundredths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the tenths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the tens place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the tenths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the tens place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

VIN number is stamped on the lower frame in the back of the left front wheel well.

User Avatar

This is two problems. To convert a ratio to a decimal, divide the first number by the second number. To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the thousandths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

The number of 3-digit numbers with no repeated digits is simply 10x9x8 = 720, if you allow, for example, 012 as a 3-digit number. There are 10 digits, any of which might be the first digit. The second digit can be any digit except the digit that was used for the first digit, leaving 9 possibilities. The third digit then has 8 possibilities, since it can't be the same as the first or second digit. The actual number of possible area codes will be lower, because there are additional restrictions on the number combinations for a valid area code. For example, in North America (USA, Canada, etc.), the first digit of an area code cannot be 0 or 1 and the middle digit cannot be 9.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

The lower the digit count the older the account is.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the tenth of a centimeter. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the hundredths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the hundredths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the hundredths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the tenths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the ten thousandths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the hundredths place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.

User Avatar

To round a number to a particular digit, look at the digit immediately to the right of your target, in this case, the ones place. If that digit is 4 or lower, zero it and everything to the right of it out. If that digit is 5 or higher, increase the target digit by one and zero everything to the right of it out. If your target digit is a 9, increasing it will turn it to zero and increase the digit to the left of it by one.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.