The trans switch regulates the rpm's most of the time when you are in a single gear the comfort will change gears at about 5000 rpm and in power it allows it to go to 6000
The Power/Comfort button on late model Jeep Cherokee Laredos changes the transmission shift points depending on the selection. Pulling a boat? Use Power. The Comfort setting smooths out the shift points for a more comfortable ride.
This switch changes the behaviour of the automatic transmission; in the Power position, the transmission will shift up and down at higher engine speeds. In the comfort position, the upshift points will be limited, i.e. at Wide Open Throttle the shifts will not be at maximum engine RPM as they will be in Power position. The easiest way to demonstrate this is to drive on a highway at approximately 45MPH (70KPH) and force a kickdown (press the gas pedal to the floor). In Comfort mode, the transmission will shift down into third gear from fourth; in Power mode it will shift down into second gear. The difference is very noticeable. From 1991 onwards, the switch connection at the Transmission Control Unit (TCU) was hardwired in Power mode - no switch.
A/T - stands for Automatic Transmission. This is your trans. mode switch. Comfort Mode- It shifts quickly and smoothly. Power Mode- It revs up higher before shifting. Auto Mode-It picks power or comfort mode for you, power when you accelerate hard and comfort when you are going normally.
Use a test light on the wires just before the motor to test for power if no power you can test for power at the switch/// you can test the motor by runing power from the battery.
The 1993 Ford Bronco power door lock relay switch can be found behind the dashboard on the drivers side of the passenger compartment. The relay switch should be labeled as such.
If there is a switch below the window controls on the drivers side door, flick it, that would be the override safety switch. It's labeled window lock.
I can not understand your question.
First place I would look is the fuse box near the drivers kick panel. There are blade terminals that supply power and they are labeled. They may be unplugged. Have you pulled out the switch and checked the pins?
the power switch on a camera turns on or off the camera.
Power steering pressure switch.Power steering pressure switch.
A. Comfort has written: 'Darwin and the Naked Lady' 'Wreath for the living' 'The power house'
The headlamp switch controls the power to the dimmer switch and then on to the headlights.The headlamp switch controls the power to the dimmer switch and then on to the headlights.
The switch on the back is the switch for the power supply only. The computer boots from the main power switch on the front. This particular method of switching was introduced with the ATX power supplies.
next to the battery
it is #26 30amp
The power on switch
remove door panel check to see if you are getting power and ground to motor. If so, bad motor--if no power to motor, check to see if you have power to switch if so ,bad switch--if not bad power feed to switch close but if the switch not on, you never get power to the motor.
A power window relay switch relays the power from the car's battery, to the switch itself, and then to the window motor. When pressing the button inside of the car it allows the power to go from the relay switch to the motor and roll the window up or down.
Allright with a voltimitter check your switchs so when you roll them up or down you have power to the switch if not its your door switch. if you do have power check if you have power to your motor. there is no relay switch theres only fuses.
Check the fuse in the fuse box in the engine compartment labeled ECI (Electronic controlled injectors) They share the same power circuit as the fuel pump.
Power is being interrupted; the turn signal switch is a power juction see if the power is flowing thru it.
The 2004 Acura is equipped with several power relay switch is. Some of the power relay switch is are located in the fuse box. Some of the power relay switch is our mounted to the firewall.