answersLogoWhite
Auto Parts and Repairs
VW Passat
Ford Bronco
Turn Signals and Hazard Lights

What else can be checked if the turn signals on a 1997 Olds Achieva SC stopped working but the bulbs and fuses are good?

434445

Top Answer
User Avatar
Wiki User
2004-08-15 09:34:34
2004-08-15 09:34:34

Hey April==The flasher should be under the dash to the left of the steering column in the wiring. Goodluck Joe

1

Related Questions

User Avatar

check if reverse lights are working, if not replace the reverse switch plug located underside near the gear box, centre of car, there are two plugs, check if wires are frayed, this happened to me and when I replaced this my turn signals started working. hope this helps

User Avatar

More than likely the Flasher Relay is defective. Replace it.

User Avatar

your fuse is to strong try a lower fuse or some other one is wrong sending too match power that why to blows, or is your headlight cracked?

User Avatar

The bulbs should be checked on a 1993 Dodge Dakota if the taillights are not working. The plugs on the trailer package should also be checked to make sure that they are working.

User Avatar

sync server has stopped working mdcrash reporttool has stopped working.?

User Avatar

A car radio that has stopped working will need to be checked for wiring problems or a problem in the radio itself. The car dealer should be able to track the source of the problem to let you know how to proceed with fixing it.

User Avatar

my turning signals dont work on my 91 integra LS. They were working a day before. so the next day they werent. I also had battery problems but i had checked every single fuse and the fuses arent burn. My turning signals do not work what so ever.

User Avatar

Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead

User Avatar

skype has stopped working which program caused the problem

User Avatar

Borrow a freinds charger or something, then you will be able to tell if it is the chrager that ain't working

User Avatar

i fnone of the turn signals work, the first placeto look is the flasher can. this is a clyander usually located in or near the fuse box. there are 2 of these.1 is for turn signals, other is for 4 way flashers

User Avatar

It could be the turn signal bulbs, some vehicles use separate bulbs for the hazard and turn signals. It could also be a bad switch or wires for the turn signals.

User Avatar

ice maker has stopped working for a ge

User Avatar

My wrx 1995 stopped working because of the carbon brush on the rear of the wheel. fitted after market neon horn swith to dash to get round it.

User Avatar

Not typically. answer yes the hazard lights stop turn sinals from working there are only 2 elements in the bulb one for stop and one for turn hazars use same eement as turns signals it is for that reason that it is illegal in most states to actually drive with your hazards working they are supposed to be used only when stopped

User Avatar

If both turn signals stop working at the same time in both the front and rear of the car, there are two main causes. First, the fuse might have blown, or second, the mechanical or electrical connections may have gone bad.Ê

User Avatar

either the wires are bad and need replaced or your computer is getting ready to take a dump so i suggest trying to replace the wiring for the fan and put in a new switch for the turn signals


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.