why don't you guys take it to a shop and get it fixed, that's why we are here.
There is no brake light relay. There is however a brake light switch located above the brake pedal.
I believe that is a defective daytime running lamp (DRL) module
The switch isn't repairable and should be replaced if bad. It's located on the bar where the brake pedal is attached.
Check your owner manual for fuse location and description. Probably just a bad fuse.
The brake light switch may be bad or out of adjustment. The switch is located just above the brake pedal.
check brake fluid
Brake light on 1994 Honda civic staying on.
AnswerCHECK BRAKE LIGHT SWITCH UNDER DASH LOCATED JUST ABOVE BRAKE PEDAL.there is another switch next to arm on the brake peddle that slides up and down when you work the peddle . mine was loose
On the drivers side of the firewall.
The brake fluid reservoir in your Ford Explorer is in the engine compartment , near the firewall . It is on the drivers side of the engine compartment .
if the tail lights work but not brake lights then its most likely just a blown fuse or it could be the switch at the top of your brake pedal arm.
Check the operation nd alignment of the stop light switch located at the upper end of the brake pedal under dash area
Common issue...if the brake light swith is not working; the cruise control will not engage and your brake lights will not go on. replacing switch is easy and inexpensive...its located in the upper part of the brake pedal.
usually it is a fault with the brake light switch located on the brake pedal arm. there is a plastic button that sometimes disintegrates and no longer allows contact with the switch. Check that first. You can find a replacement by using a body fastener.
Defective or mis-adjusted brake light switch
Most likely the brake switch. Not for sure with this model, but brake switches are almost always easily accessibile being located somwhere in line with the brake pedal.
On the brake pedal assembly.
The brake light switch is located near the top of the brake pedal. When the pedal is depressed the switch is activated and sends current to the brake lights. To access the switch, the under dash panel needs to be removed.
If the brake lights stay on when the car is not running on most vehicles, including the 1994 Dodge Intrepid, there is probably a short somewhere in the wiring to the brake lights. The first place to investigate this problem would be the wires along the firewall that control the brake lights. Also, check the brake light switch above the brake pedal.
Working brake lights are important for safety reasons while driving. It is important to check all of the wiring, if the brake lights are not working and the fuses and bulbs have been checked.
Yes , on the back wheels ( disc brakes on the front )
It should say TAIL for taillights or maybe brake lights.
Brake Lights Stay on Unless the Brake Pedal is RaisedThis is usually caused by the brake light switch being out of adjustment in its physical distance to the contact point on the brake pedal arm.
It is mounted to the left of the brake pedal under the dash.