You will need to remove the short section of exhaust pipe just down stream from the "Y" piece. The starter can then be removed fairly easily. You will need to replace the exhaust gaskets, the gasket on the downstream side is kinda hard to find. Before you try to remove the exhaust flange bolts spray them with a lot of WD-40 and let sit for awhile. You DO NOT want to break those bolts! Also, be sure to disconnect the battery!
to change the starter for Isuzu trooper is easy way to oper the exhaust pipe first.then you can reach easly to starter.
The starter on a 94 Isuzu Trooper is located on the bottom, passenger side of the vehicle. It is found at the rear of the engine, at the flywheel.
It is located on the flywheel.
bypass key on a trooper
The starter for the 1992 Isuzu Trooper was a little difficult to locate, honestly. One may find it on the driver's side of the motor, directly above the oil pan.
under the hood in the fuse box
Isuzu Trooper was created in 1981.
Starter Relay Isuzu Trooper (Diesel Engine) located in fuse box (engine room), grey color. They have 4 relay (Power Windows-black, AC-black, Engine/Alternator-blue, and Starter-diesel engine-grey)
Just removed mine; the started is on the driver side of the engine; you got to remove part of the exhaust pipe to get it out; once that's remove the rest is easy.
From what I understand, you have to diconnect the exhaust system on the side that the starter motor is located on. To reassemble you have to replace the exhaust gasket with a new one. If you are replacing the starter, there is a GM starter that is a direct replacement for the Isuzu starter and costs quite a bit less.
1999 Isuzu trooper
timing marks for 1996 Isuzu trooper
The 6VE1 3.5L V6 fitted to the Isuzu Trooper was manufactured in-house by Isuzu themselves
The trooper is made by Isuzu
I found that the easiest way to get to the starter of an 1987 Trooper II is to take the front right wheel off. You should see it right there, and with relatively easy access.
Remove Camshaft fro isuzu trooper 1996
Take out the transmission and there it is. The flywheel holds the ring gear for the starter. If your ring gear has been obliterated by your starter you have an issue with how the starter engages the fly wheel to begin with. Proper clearances, alignment and securing of your starter will make your trooper whole agian.
Glow plugs can easily be change on an Isuzu Trooper 3.0 TD. The old ones must be removed first and then the new glow plugs are installed using the same connections.
will a 3.2L 2000 Isuzu Trooper engine fit a 3.2L Isuzu rodeo transmission
The sister vehicle of the Isuzu Trooper is the Acura SLX
just behind the wheel well of the right front tire its a silver color looking thing
The spark plugs in this car are on the side of the engine. They are seen after the engine cover is removed.
Where is the fuel cut of switch for a 03 isuzu trooper
how do i line up timing gears on 2.8 isuzu trooper
How do you change the transmission fluid on a 2001 4x4 Isuzu trooper