Ford Thunderbird
Thermostats

What if the thermostat in a 1994 Ford Thunderbird leaks water?

303132

Top Answer
User Avatar
Wiki User
2011-09-13 12:36:43
2011-09-13 12:36:43

I have two tbirds, a 95 5spd Supercoupe, and a 92 Auto Supercoupe, both vehicles drip from their thermostat housing slightly, and has never been a problem, Have tried multiple times to correct... even after new jasper engines were professionally installed it still happens. In fact, ALL SC's I have ever seen show evidence of leakage :P-BCP

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Follow the top radiator hose back to the engine. This is where the thermostat is. Remove the 2 bolts and there it is.

User Avatar

Can you put a 1994 thunderbird motor in a 1996 thunderbird?

User Avatar

bolt pattern for a 1994 ford thunderbird

User Avatar

Drain the water from the cooling system. Remove the water hose from the thermostat housing. Remove the thermostat housing retaining bolts. Reverse the process to install the new thermostat.

User Avatar

How to install thermostat in a 1994 volkswagen golf?

User Avatar

On the 1994 Lexus 300es, the thermostat is located in the front of the engine. Look for a radiator hose just below the location of the water pump. The thermostat is inside the end of that hose.

User Avatar

The location of the thermostat in a 1994 Corolla 1.8L is in the top radiator hose. The thermostat is in this hose where the hose meets the water pump.

User Avatar

THe reassembly didn't go well. A failed seal, a cracked hose or similar.

User Avatar

the thermostat is next to the water pump. Follow the lower radiator hose from the rad to the engine. that is were you will find the thermostat.

User Avatar

3/4 coolent 1/4 water. that's it!

User Avatar

Standard tyre size for 1994 Ford Thunderbird LX 4.6L V-8 automatic is 205/70R15

User Avatar

Remove the water supply hose from the top of the thermostat housing. Remove the thermostat housing retaining bolts. The old thermostat will simply lift out. Reverse the process to install the new thermostat.

User Avatar

follow hose from radiator to engine block. there are 2 bolts that hold the housing in place. BE CAREFUL when you re-tighten the bolts and do not break off the ears on the thermostat housing. and make sure the engine is cool and there is no pressure

User Avatar

Follow the top radiator hose down to the water outlet; your thermostat is in here. Mark

User Avatar

For a 1994 Ford Thunderbird : ( DOT 3 brake fluid , meeting Ford specification ESA-M6C25-A )

User Avatar

A 1994 Ford Thunderbird is ( OBD I )

User Avatar

The 1994 Chevrolet Beretta thermostat is located on the front of the engine. You can follow the top radiator hose directly to the thermostat housing. The thermostat will be in the thermostat housing.

User Avatar

it could be a bad thermostat or lack of water/coolant in the engine itself. Coolant will boil itself away if it was not mixed right. If the thermostat is sticking or not working, it wont let coolant that is in the block move past the radiator to cool, allowing the temperature of the block to increase and over heat Thermostat not opening?

User Avatar

back side of motor under exhaust manifold with the water pump

User Avatar

The minimum brake rotor thickness for a 1994 Ford Thunderbird car is .974 inches for the front rotors and .657 inches for the rear rotors.

User Avatar

Please advise where the radiator cap is located on a 1994 ford thunderbird. I have to add a stop leak product to stop antifreeze leak and I cannot locate the cap.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.