If the wattage load is higher that the rating of the dimmer switch then do not use the switch on that circuit. The manufacturer's components of the switch are only rated at a specific rating. Going higher than that rating will destroy the device and void any warranty that the switch might have. Always size the device to the load that you are wanting to control.
Find the wattage rating on the dimmer controller. This is the maximum allowable wattage that the lamp in the fixture should be. Lamp wattage ratings under the rated dimmer wattage is fine but do not install a larger wattage lamp that is over the dimmer control's rating.
A dimmer switch is used for lighting loads and not heating loads. The wattage rating on a dimmer switch is what the manufacturer recommends as the maximum load that the switch can handle. For example if you have ten 100 watt lamps, the total load wattage would be 1000 watts (10 x 100). Too much load for a 600 watt rated dimmer switch but not for a 1000 Watt rated dimmer switch. So you can see that the rating on a dimmer switch governs the maximum wattage load that can be connected in the circuit that is to be controlled.
Look on the carton that the dimmer comes in. On the label there will be a list of lamp types that the dimmer can be used on along with the maximum wattage that the dimmer can control.
the dimmer should have a rating on it in Watts. dimmers are not suitable for low energy lamps though
Remember that dimmers are for incandescent lights only unless you invest BIG BUCKS on dimmable fluorescent lights and fluorescent dimmers. Make sure that the switch that you replace with the dimmer does not control a plug-in outlet unless it is a lamp. You could do harm to an appliance not designed for such use. Otherwise,just add up the wattage of all the bulbs on the dimmer and buy one of the next size rating. So if you have two 60 watt bulbs, two 75 watt bulbs-- that's 270 watts total.Find a dimmer rated for 300 watts or more.
No, the voltage rating of the switch is too low.
No a switch just opens and closes a circuit. A switch can be replaced by a dimmer switch. The dimmer switch will fit in the same enclosure that the switch is removed from.
dimmer switch dimmer switch
The 1993 BMW 325 dimmer switch is located on the lower left-hand side of the dashboard. The dimmer switch is a dial switch.
The dimmer switch is located near the floor on the left side of the steering column. The dimmer switch and ignition switch are secured by the same two screws. The dimmer switch will be the one on top. Loosen and remove the screws, disconnect the wiring harness from the dimmer switch and replace with the new switch, complete the assembly in reverse order.
How do I change the dimmer switch on my 1993 corvette?
It is very simple to install a dimmer switch in place of a regular light switch.