Have it cleaned out and flushed immediately
you will have to have it towed to a shop to have the trans flushed; do not drive it!!
Accidentally pouring transmission fluid into the brake fluid reservoir is a serious mistake and can have detrimental effects on your vehicle's braking system. Transmission fluid and brake fluid serve completely different purposes and have distinct properties. Transmission fluid is designed for lubricating and cooling the transmission components, while brake fluid is crucial for the proper functioning of the braking system. Brake fluid is a hydraulic fluid that transmits force within the brake system, and it has specific properties to withstand high temperatures. If transmission fluid is added to the brake fluid reservoir: Loss of Brake Functionality: Transmission fluid is not suitable for use in the brake system, and it lacks the necessary properties for hydraulic braking. Mixing the two can compromise the integrity of the brake fluid, leading to a loss of braking functionality. Damage to Brake Components: Brake seals, hoses, and other components are not designed to handle transmission fluid. The introduction of transmission fluid can lead to damage to these components, resulting in brake system failure. Reduced Braking Performance: Transmission fluid may cause the brake fluid to become less effective, leading to reduced braking performance. This compromises the safety of the vehicle and increases the risk of accidents. If such an error occurs, it is crucial to address it immediately: Do Not Drive: Refrain from driving the vehicle as compromised brake functionality poses a significant safety risk. Professional Inspection: Seek the assistance of a qualified mechanic to inspect and flush the entire brake system. Flushing involves removing the contaminated fluid and replacing it with the correct brake fluid. Component Replacement: Depending on the severity of the contamination, brake components may need to be replaced to ensure the safety and reliability of the braking system. In summary, mixing transmission fluid with brake fluid can lead to severe consequences, and it is essential to rectify the mistake promptly by seeking professional assistance to prevent safety hazards and potential damage to the vehicle.
Don't drive it, but have it towed to a reputable garage that can flush the transmission. Driving it with the oil may cause serious damage to the transmission.
I am not a mechanic, but I know you have a problem. I would suggest draining the transmission and replacing it with the proper fluid. I wouldn't drive it because I think that might worsen the problem.
Brake fluid can corrode your water pump. If you didn't start the engine after installing the brake fluid, then pump the reservoir empty, flush it with water and refill it with proper coolant. If you DID start it, you need to flush the whole cooling system.
you open the cap that says brake fluid, and then you pour it in
Locate the brake fluid reservoir, and pour brake fluid in until it's at the appropriate level.
Pull out the transmission dipstick and pour in fluid with a narrow necked funnel.
Assuming we are talking about an automatic transmission, you remove the transmission dip stick and pour fluid into the dipstick tube.
Buy a transmission funnel and pour the fluid in the dipstick tube.
In the engine compartment , on the drivers side , in the brake fluid reservoir by the firewall ( use DOT 3 brake fluid )
where do you pour transmission oil on a 5 spd