It is an open circuit in the drivers airbag. There is a clockspring behind the steering wheel that may be worn. To replace, remove airbag, steering wheel, column covers, and lower dash cover. MAKE SURE WHEELS ARE STRAIGHT. The new clockspring comes centered with a yellow locking tab. Remove that after installing it.
In the glove box.
passenger side panel, above left knee
Trouble code P0102 means: Mass or Volume Air Flow Circuit Low Input
Trouble code P0731 means:Gear 1 incorrect ratio
under glove box
Follow the troubleshooting tree that is associated with that code.
Code P1506 - Idle air control valve over speed error
its in the trunk on a sticker or under the hood or inside the door
it has a malfuction so its setting a code
PO708, Transmission Range Sensor Hi Output circuit.
intake manifold runner control malfunction (stuck open)
Trouble code P0125 means: Insufficient Coolant Temp For Closed Loop Fuel Control
Code P1237 indicates a Fuel Pump secondary circuit malfunction, including an open or short circuit.
Where is the EEC connections for a code reader on a 1995 Mercury Cougar? Is there any suggestions why the engine won't turn over. Only a ticking sound is heard and sparks from the battery sometimes appears when trying to start.
Trouble code P0401 means:Exhaust gas recirculation flow insufficient detected
mounted under the glove box
Error codes on a 1997 Mercury Villager can be found by connecting an OBDII code reader to the diagnostic port. The service manual has a full list of error codes and their causes.
You won't know until you get the code read.
There are three catalytic converters on a V6 Mercury cougar. You have two pre-cats, one on each exhaust manifold, and a main Cat just after the Y pipe. Note, if you are removing or gutting the pre-cats, use MIL eliminators to stop the car from throwing a code.
You will find a sticker in the trunck with the factory code printed on it.
Secondary Air Injection System Incorrect Flow.
It stands for the safety restraint system. That includes the airbags and seatbelts. If the light is staying on, the computer has detected a malfunction and set a code.
Its a dealer code, transmission related. Take it to your dealer for professional diagnosis. just had it done dude it is the torque converter look up the code p1744 and it will tell u
I have a p0708 code on this cougar 1999 2.5 with a p0420 code also what sensor should i replace
if your cougar has a keypad under the door lock mechanism the code is in the trunk open your trunk and look on the trunk hinge to your left there should be a sticker with a 5 digit code that is your keyless entry code if it isn't there or the code doesn't work the trunk lid has been replaced