Mazda RX-7

What is a 1987 Mazda RX-7 worth?

345

Top Answer
User Avatar
Wiki User
Answered
2008-12-15 12:28:50
2008-12-15 12:28:50

around 1 to 4 thousand

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


http://www.petting-zoo.net/~gkm/rx7/specs.html


mazda doesnt rx7 anymore :(


yes, however you may need to adjust the wire harness to fit.


Can you please verify between Synthetic and Mineral?


The Mazda Rx7 has the Wankel Rotary Engine in it


2-3 thousand based on its condition


none, keep the rotary in it.go buy a honda, dont ruin an rx7


sounds like a sparkplug is fouled or the timing is off


It depends on how many lugs there are. If they areboth 5 lug than it will fit. If the 87 is 4 lug then you would have to change the hubs to 5 lug.


Mazda didn't make the RX7 in 1974.


No. 86-88 are the same. 89-91 are the same.


from everything i have seen, the fronts are 4" and the backs are 6.5"


Yes, there is a transmission in a 1990 Mazda RX7 convertible.


how do i get the air out of my radiator 1987 rx7


The Mazda RX7 was made discontinued in 2002. Mazda replaced the RX7 with the RX8 in 2003


Depends, which engine is in the 85, 13b or 12a?


on fast and the furious Tokyo drift,Han was driving the Mazda rx7.


The Mazda cx7 is not as good as the Rx7. The Rx7 has more power, better fuel efficiency and a sleeker appearance. The Cx7 is actually not as good as a Honda CR-7.


If a person would like to purchase a used Mazda RX7, it is easy to do so. The Mazda RX7 is available at any Mazda or Mitsubishi dealership which specializes in used vehicles. Additionally, a person may check their local automobile classified advertisements for a used Mazda RX7.


No the Mazda RX7 is only rwd


bottom of car under the driver side.....near the engine bay


The spring rates for the 1987 Mazda RX7 are different between the front and rear. On the front, the spring rates are 180 millimeter in length and rated at 12 kilograms per millimeter, while the rear sports 200 millimeter length but 10 kilograms per millimeter.


Well yes and no. You can put them on your rx7, but the spring rate and stiffness may be too much or too little for your rx7 and it will need to fit the specific shocks/struts of your rx7.. The springs may have to be cut also depending on the clearance needed, give it a shot, and install it and see how it clears. if it clears, test drivie it in a safe area.


idk i think like 25 or 30 my uncle has one or just look for the answer on www.ask.com


If you look on the driver side back by the break pedle you will see the fuse panel



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.