Auto Parts and Repairs
Nissan Frontier
Nissan Maxima
Air Filters and Intake Manifolds

What is a reasonable amount of time and cost to replace an intake manifold gasket and an EGR valve on a 1999 Mercury Mountaineer 6-cylinder OHC?

242526

Top Answer
User Avatar
Wiki User
2014-10-06 19:39:58
2014-10-06 19:39:58

It should take 1.5 hours to do the intake, assuming a rate of $99 an hour for labor plus parts it should be around $200. It should take one half hour for the EGR valve but the part is expensive so around $300 total for that.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

No,a transmission on a 2005 mercury mountaineer will not fit on a 2000 mercury mountaineer unless you change the oil message on the mountaineer.

User Avatar

The EGR valve on the 2001 Mercury Mountaineer is located on the engine block just to the left of the intake manifold. The damaged valve will cause the check engine light to flash.

User Avatar

In a 1997 Mercury Mountaineer : r134a

User Avatar

No , a 2000 Mercury Mountaineer is body on frame

User Avatar

In a 1997 Mercury Mountaineer : ( 4R70W )

User Avatar

where is the speed sensor on 2002 mercury mountaineer

User Avatar

how to change spark plugs on a 97 mercury mountaineer

User Avatar

where is the location of the vehicle speedometer sensor on a 99 Mercury Mountaineer

User Avatar

The first model year of the Mercury Mountaineer was 1997

User Avatar

On a 2001 Mercury Mountaineer : Underneath the Mountaineer , below the drivers door , mounted on the frame rail

User Avatar

No , a 1997 Mercury Mountaineer is not designed to have a third row seat ( the 2002 and newer Mercury Mountaineer were designed to have a third row seat )

User Avatar

How do I replace the fog lights in my 03 mercury mountaineer

User Avatar

How do i change the chain out of my 1998 mercury mountaineer transfer case

User Avatar

The Mercury Mountaineer has hydraulic brakes, not air brakes.

User Avatar

For a Mercury Mountaineer : ( " regular " unleaded gasoline , 87 octane )

User Avatar

The first model year for the Mercury Mountaineer SUV was ( 1997 )

User Avatar

According to the ( 1999 ) Mercury Mountaineer Owner Guide : ( the length is 188.5 inches )

User Avatar

If you have a 1997 to 1998 Mercury Mountaineer or Ford Explorer with a V8 engine, you will have a 4R70W transmission.

User Avatar

how do you change wheel bearing on 98 mercury mountaineer

User Avatar

The first model year of the Mercury Mountaineer was 1997

User Avatar

The engine is fuel injected so there is no carburetor on a 2000 Mercury Mountaineer

User Avatar

where is the tire jack and jack handle located on a 2002 mercury mountaineer?????

User Avatar

Where is the location of the EGR valve on a 1997 Mercury Mountaineer V*


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.