What is a resonator on a 1994 Toyota 22re motor do?
A resonator on any car is to help the muffler keep the exhaust noise level to a minimun.
The recommended spark plug gap for a 1994 Toyota 22RE is .032"
need photo of return fuel line off motor from a 89' toyota p.u.4x4 with a 22RE motor
5 with the oilfilter
Five Quarts with filter change!
i have a 22re engine in my pick up aqnd i use 10w30 all year round
Are you trying to imitate Transformers or something?
22r or 22re unless it's been changed.
The recommended spark plug gap for a 1986 Toyota 22RE is .032"
i just replace the motor mounts with supra mounts
it should be attached to the back of intake manifold ad to the back of the cylinder head
what does the ignitor assembly do on a 87 toyota 4runner(22re)
Sure.. just pull the wiring harness to run the EFI. the carb motor harness wont run the efi.. yes it will. i did it in my truck
The correct gap for the 22RE (4 cylinder) is .031
Yes, I am aware that the celica and supre vehicles also had the engine. Late 70s early eighties.
whats the first step on repairing my 1993 Toyota truck 22re with a high idling problem thanks Brian
Ive heard a few different answers. Depends on if your including accessories, but 315-340 lbs seems to be in the ball park
Bolt pattern and torque specs are here: http://toyota.offroadforum.cz/aarc.epnet.com/application/8578/8578R03_Cylinder_Head.html
nothing 22ris carberated and a 22re is efibut the basic motor is the same
some companies make conversion kits to put motors such as chey-305,350. theres also others such as v-6's. But if you wanna keep it all Toyota you can get a 22re motor from lcengineering.com with up to 50hp increase. all depends on you and what you want.
i have the same question, in my Case in the CD instruction in any part Sade's how to install the jawdropper chip on my toyota hilux 1994 22re
four and a HALF
1981-1995 22r- 22re new hgt.- 3.790-3.800 -min. hgt.-3.780
Possibilities: Fuel mixture is WAY too rich OR the timing is out of spec.
Im not really a mechanic but i believe it might burn valves. If it is a 22re toyota pickup motor they are supposed to tap overtightening them may lead to a burnt valve.
It's inside the alternator
22RE or the 3.0L.
i know from 1984 to 1994 22r 22re and 22rtec all shared the same bell housing just that some had dowl pins different places
Is the AC turned on?
the spark gap is 0.80
If the noise sounds like a banging sound it could be that you have a worn timing chain. Note: 22re's have timing chains not belts. You should have the noise checked-out by an experienced Toyota mechanic.
I am currently changing a head gasket in a 93 Toyota 22re. I'm willing to share info on the process. I had to grind one of the head bolts off to get it out, I'm also replacing the timing chain.
The fuel filter on a Toyota pickup having a 22re engine is located on the left side, directly under the intake manifold. It is held on by two 12mm bolts. If you look under the truck, you will see the filter to the left of the oil filter.
take it to the crusher
8 intake 12 exhaust ????
Right below the oil filter.
The firing order on a 1993 Toyota truck with a 4-cylinder . 22RE is 1, 3, 4, 2. The number one cylinder can be found at the front of the engine, closest to the grill.
What octane of gas should I run in my 1992 Toyota pick up 22re
head gasket is leaking into oil
105 MPH for 22re manual trans
the spring should always go to the inside of the engine
76 mains 46 rods according to the Toyota service manual
the 89 toys had the 22r 22re and 3.0 v6
Full synthetic SAE 10w30.
93 Toyota pickup 4c 4wd 22re engine check engine light fine when first crunk then after 35 mph it comes on does anybody know what this could be it cause a loss of power?
If you washed the motor our presher wased it you got water where it should not be
Here: http://www.autozone.com/az/cds/en_us/0900823d/80/16/11/88/0900823d80161188/repairInfoPages.htm it's a little bit hard to figure out. It's the best I can do for you.
UNDER VEHICLE, PASSENGER SIDE, BELOW BED AREA, PASSENGER SIDE OF FUEL TANK, MOUNTED ON FRAME IN FUEL LINE You can find this stuff for free at Autozone.com under component location. if the motor is 22re its mounted on the engine right above the starter the bolts are 17mm take the plate off on the inner fender well passenger side front side
you would need to change the motor, trans, tcase and wiring harness with computer. as well as exhaust and everything else. if you want a 3.0 truck sell yours and buy one with a 3.0.
Lots of patience and attention as well as a scratch pad for notes. James