answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2008-03-24 03:27:03
2008-03-24 03:27:03

Stock rebuild- it has been said that 10psi per 1000 rpm. At idle 20-30 is about right once the engine is warmed up. Of course this will also vary with the weight of the oil used-not much but it will

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The 5.7 liter Chevrolet engine fuel pressure should be a team PSI. A range of 16 PSI to 20 PSI is acceptable.


Low oil pressure. Bearing clearences are most likely to large. New or rebuilt engine time!


eBay offers a 454 Chevy Engine Rebuild Kit. It costs $379. It has all the necessary parts to rebuilt one's own engine. The engine was used in the 1970 Chevy Corvette LS5.


Timing chains are designed to last the life of the engine and are replaced when the engine is rebuilt.


Your 1996 Chevrolet Cavalier 2.2 liter engine oil pressure should be approximately 40 psi. A range of 35 to 45 psi is acceptable.


Timing chains are designed to last the life of the engine and are normally replaced when the engine is rebuilt.


The oil pressure switch on a 1997 Chevy Tahoe is located on the back of the engine. It is in the center-rear part of the engine.


Timing chains should last the life of the engine and are normally replaced when the engine is rebuilt.


That depends on what engine it has.


have the transmission rebuilt Itll cost about $1600


Not sure, i would say oil pump or cam bearings


Where is the fuel pressure regulator located on a 1989 chevy silvarado with 5.7 liter engine


The Oil Pressure Switch is located on the driver's side top rear of the engine on your Chevy Pickup.


We do not know what you are asking / question is. Please ask it again with all detailsThanks.



1996 to 2002 2.2L engine needs 41 to 47 psi fuel pressure.


The standard fuel pressure for a 1998 Chevy 3500 with a 454 engine is 50 PSI. If fuel pressure drops much below this level, the fuel injectors will not work properly.


I rebuilt my 231 (3800 series II, 3.8) chevy. I checked the bearing clearances several times, and primed the engine before starting it the first time. the current pressure I am seeing is about 70-80 cold and 45-60 at operating temperature. if you are seeing anything lower than 30, it is likely time for a rebuild. the oil pumps on these engines are crank driven and there is no such thing (for these) as a high pressure pump.


Your question really makes no sense. Normally a timing chain will last the life of the engine as replaced when the engine is rebuilt.


The 1998 Chevy S 10 Blazer 4.3 liter engine fuel pressure regulator will be on top of the engine. The fuel pressure regulator will be attached to the injector fuel pump.


It's on the passager side inside the engine department


If you are asking what the pressure should be, it should be 5-6 psi but we really need to know what year and engine that Chevy has to correctly answer that.


Engine oil pressure, cooling system pressure, ac pressure, fuel pressure?


We are going to need to know what engine it has.


The engine needs fuel, compression and spark to run. You are missing one of those. Whoever did the install forgot something.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.