What is axle nut size for 1993 olds cutlass supreme?
How do you replace a axle on a 95 holds cutlass supreme
i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?
I HAVE A 1992 OLDS CUTLASS SUPREME JUST BE FOR it warm up it cuts off
They are hydraulic and not adjustable
Where is the water pump on a 1995 olds cutlass supreme?"
At the firewall on the passenger side
Injectors are clogged
Right next to the passenger side tire. Above the control arm.
Open the glovebox, pull out the black comparment, look down and you will find the fusebox.
I am trying to take the motor out of a 95' Olds cutlass supreme. The trans. is giving me problems. How many bolts hold it in.
If you have never done one before. Don't without the correct manual in front of you.
it probably doesn't have one...my 1993 doesn't My 1995 Olds Cutless Supreme SL 3.1L has a yellow trunk button in the glove box.
show me how to set the timing on a cutlass supreme olds
what are the timing belt marks for a 1995 olds cutlass supreme
maybe you can look in the fuse box located under the glovebox and replace the electrical fuse.
Do throttle body service on vehicle Do idle/air control motor service on vehicle
Weak battery Bad or corroded battery cables Bad starter solenoid
how do you change a thermostat on a olds cutlass supreme 1983
The low side service port to recharge the AC on a 1997 Olds Cutlass Supreme is at the rear of the engine. It is close to the firewall.
wher is the pcv located on a 1996 olds cutlass supreme 3.4 l engine
i had same problem on my 94 cutlass supreme...long story short, it was the ignition switch. $300. at shop.
I'm a single woman and i need to change the air charge temperature sensor on my 1993 olds cutlass supreme. i need a "how to" please.
I have a 1993 olds cutlass ciera and the AC fan relay is the one in the middle on my car.
There were a reported 8,638 Olds Cutlass Supreme convertibles sold in 1994
they are 205/60/r16
72 olds cutlass supreme
Not from the factory.
How to change the motor in a 1993 olds cutlass supreme without taking out the transmission or with taking out the transmission is it possible to get a diagram on how to do it all it is a 3.1 liter v6?
you can leave the transmission in or you can leave in the transmission
The fuel pump in bothmy 1988 and 1989 olds cutlass supreme sl are in the fuel tank they're ALWAYS in the fuel tank!! haha
From what I have read at Automotix.com , I will say yes it will. You also have other options of engines from Chevrolet, Buick, as well Oldsmobile that fit the Cutlass Supreme. The engines vary from V6 3.8L, 4.3L V6, 5.0L V8, to 5.7L V8, depending on what year and transmission type your Cutlass Supreme has. Check with some of the Remanufactured engine websites, or talk with a shop in or near your area that… Read More
The license plate light on a 1995 Olds Cutlass Supreme can be replaced by accessing the bulb through a hole in the bumper next to the license plate. A person may need to do this from underneath the vehicle.
I also want to know that...
where is the diagram on a alternator belt ..huh?
assembly manual off eBay
Is located under the coil packs
What is the firing order for a 1990 olds cutlass supreme 3.1litre and where is 1 and which the cyl are 123456 or what?
The firing order for a 1990 Olds cutlass supreme 3.1litre is 1, 2, 3, 4, 5, 6. The number one cylinder is closest to the pulleys on the left as you face it.
The 1993 Cutlass doors lock automatically as a safety feature. This helps to keep the doors from accidentally opening or someone trying to enter your cat at a stop light.
this link will help
Nee more info cutlass supreme or cutlass ceira which engine 3.1-- 3.8-- 3.3-- ????? Oldsmobile cutlass ceira 3.3 liteer engine
199X Olds Cutlass Supreme
5 bolt olds rim
towards the firewall, it is red.
Use a 10mm socket.
diesling is caused by bad spark plugs
go to your local auto parts store and ask for it.
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
Go to the GM dealer near you and ask for a price on the part; when they are pricing it for you they can print out a copy of the page for you from their computer; this will identfy the location because adjacent parts are pictured with it. This is what I do.
yes they are they did change calipers until 96