0
What is better for getting more torque going down teeth or up teeth in front sprockets on a motorcycle?
Wiki User
∙ 13y ago
Strictly speaking the only way to get more torque out of the motor is to tune it. But you can get more torque/faster acceleration (and lower top speed) at the rear wheel by going to fewer teeth on the front sprocket.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Will a bigger sprocket on the front give you more acceleration?
The key to better acceleration or higher top speed is ratios, but if you change to a smaller sprocket at both ends the changes will cancel each other out and leave you pretty much where you started. If you want faster acceleration go for a smaller front or for a bigger rear.
What sprockets should I use to give a minimoto more torque?
For more torque you want a smaller at the front and/or a bigger at the back. It might lower top speed though.
What is tourque?
Basically turning strength. You can get more torque by a wrench than you can by a screwdriver. An engine with high torque is better at getting things moving and accelerating.
Can a torque wrench improve my motorcycle?
A good torque wrench is an essential tool for even the most basic motorcycle maintenance and repair. It's important to ensure that all of the fasteners on a motorcycle are tightened to specifications for reasons of safety and to maintain its original design integrity. The torque wrench is used for tightening and loosing bolts on the motorcycle so you could improve the torque of the motorcycle therefore increasing its overall throttle. It could be used on the Yamaha Z5000 to either loosen or fasten bolts based on weather conditions.
How do the drive sprockets help a bike?
upgrading the sprockets can allow you to trade some effective top-end HP for added effective low-end torque, to give you faster acceleration (at the sacrifice of absolute top-end speed)
Which is better high or low Lawn mower torque?
Higher torque is better - look for 6.75 and above in torque.
What is the torque setting for Suzuki GS500 motorcycle rear wheel?
47 Ft./Lbs
What is the head bolt torque for a Honda xr 100 motorcycle?
21 ft lbs
Why motorcycle engine rev so high?
because a motorcycle engine is smaller in comparison to a cars engine. a motorcycle also puts out more power for its size than a car engine. To do this it must create a large amount of centrifugal force and to do this it spins faster. This reduces the maximum amount of torque available, but due to the small size of motorcycle, and rider, the torque is not necessary, and can even be dangerous. A car requires alot of torque in order to move, so the engine must be made of heavier materials and moved slower.
At what RPM should you change gears on a motorcycle?
Depends on the torque of the motorcycle and the road conditions. Generally, don't let the engine labour and don't make the engine scream.
How much horsepower and torque does a KTM 500 2013 have?
The producers of this motorcycle do not provide these details as far as I know.
Suzuki GSX-R1000 motorcycle torque specs?
80 ft·lbf (110 N·m) at 8,000 rpm
