In the transmission lines, there is no apparent change in the condition of air(CORONA) surounding the wires if the applied voltage is low.However,when the applied voltage exceeds the certain value,called disruptive voltage !!!
the voltage at which the properties of dielectric material (air) vanishes means ionization of air starts or formation of corona starts is called
critical.
A voltage monitor relay is in the circuit for one reason. It monitors the incoming voltage to the equipment that it is protecting usually on three phase control panels.The relay monitors the three incoming line voltages and in some relays the voltage to ground (wye connection). If the circuit the relay is protecting looses one of the voltage legs, the circuit will shut down until the problem is rectified. This usually happens if a fuse blows in one of the three phase voltage legs.It also monitors the level of voltage to the circuit. If the voltage drops due to a malfunction in the utility lines the relay will trip and take the protected circuit off line. The voltages can be set to trip at any under or over voltage usually by set point controls on the front of the voltage monitoring relay.
disruptive
Obviously it's not infinite impedance--that would mean it soaks up all the voltage. It can't be zero impedance either...that would be a superconductor, and there aren't many of those around. Voltage sources have impedance, but it's not infinite. Sometimes the impedance of the source is critical--radio frequency amplifiers have to be impedance matched to their transmitting antennas if you don't want to burn them out.
1. Field Flashing. 2. Resistance of the filed winding should be less than critical field resistance. 3. Speed of the motor should be greater than critical speed. 4. Interchange the field connections. 5. Check the commutator surface and brush.
This is the peak voltage for a 50% probability of flashover or disruptive charge.
increase the size of conductor ,provide the hallow conductor,increase the critical disruptive voltage bv providing shunt capacitors. these capacitors increases the power capacity of the line.
critical.
more disruptive, most disruptive
Bad teacher has a disruptive influence on children.
That is the correct spelling of "disruptive" (causing upset or disturbance).
Stabilizing selection.
Disruptive Technology Office was created in 1998.
Deletion is most disruptive to an organism.
The function of the altenator regulator is to regulate voltage to the ecm to avoit any damage to critical component
The function of the altenator regulator is to regulate voltage to the ecm to avoit any damage to critical component
disruptive selection