Auto Parts and Repairs
Ford Windstar
Chevy Silverado
Chevy Blazer S-10

What is involved in replacing front bearings in a 2000 Chevy S-10 Blazer 4x4?

444546

Top Answer
User Avatar
Wiki User
Answered
2011-09-13 16:14:20
2011-09-13 16:14:20

in replacing the front bearings you need to replace the entire hub assembly. approx $300 remove the brake calaiper and mount, and the rotor. Remove the star screws holing the hub in place and remove the hub. *the hub may need to be persuaded with a hammer* Mine certainly did. be careful not to damage the 4x4 actuator wire. Replace the new hub over the groved axle and put everything back together. good luck

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Replacing a wheel bearing in your Chevrolet blazer will cost approximately $175 per bearing. You can save $125 by doing the work yourself.

Its not your bearings you idiot its your brakes. Take it in and have them replaced.

You have to secure the spring. That's all I know. I've spent about three hnours trying to take out the quarter panel cover

did you check your battery and alternator?

It has 1 big hub bearing per side and you can not service them. It has factory sealed bearings. If there bad then you must replace the bearing.

Yes, the doors from a 98 Chevy Blazer will fit a 2001 Chevy Blazer with a little moderation.

Call your local auto parts store. Front wheel bearings can go from $50 to $200 (plus labor) depending on manufacture.

over charging or bad bearings its about to let you stranded change it

You need to check all 4 wheel bearings. REPLACE AS NEEDED

You have a small "EVAP" leak. Start with replacing the fuel cap.

can I put a 99 Chevy 4l60e transmission in my 86 k5 chevy blazer

my Chevy blazer power seat on my 1996 Chevy blazer isn't working

HOW TO GET A PULLEY OFF A 1998 CHEVY BLAZER

How fast are you going? Fast speed = more gas burned per mile. Slower speed = less gas burned per mile.

Where is the horn located on a 1993 chevy blazer

An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.

If you are here looking for the answer then you to invest in a chiltons repair manual for the vehicle cause it is a job that is or could be very complicated.

Yes it can be. I think you need to replace the whole hub assembly

Yes. I own a 2000 Chevy Blazer.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.