Best Answer

should be simple their is a site called they deal with engine swaps and such i believe the bell housing will swap the motor mounts will be the same if you have a computer you may have to change the injectors

User Avatar

Wiki User

โˆ™ 2006-04-03 19:18:23
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is involved when changing from a 302 to a 351 engine in a 1994 Ford Bronco?
Write your answer...
Related questions

Ford bronco 5.0 engine oil capacity?

I own A 1994 Ford Bronco Eddie Bauer with a 5.0 liter engine. The answer to your question is the oil capacity is exactly 6 quarts for an oil change.

Changing headers on a 1994 Nissan 300ZX?

You will have to remove the engine.

Vacuum hose diagram for 1994 ford bronco?

vacuum hose dimgram for 1994 ford bronco

Where is the PCV valve on a 1994 Ford Bronco with a 302 engine?

The pcv should be on the passenger side back behind the intake.

Where is the transmission fluid dipstick on a 1994 ford bronco?

look on passenger side of engine towards the back and look way down

Where is the horn relay in a 1994 Ford Bronco?

The horn relay in a 1994 Ford Bronco is located on attached to the cruise module. The electrical relay is under the hood.

Where can you get a 1994 ford bronco soft top?

1994 Bronco that has an E40D transmission in it Some times it takes a long time to shift from all gears but works well every other time?

try changing fluid and filter (if any)

Where is the fuel pump located on a 1994 bronco?

in the gas tank

Where is the fuel pump on a 1994 FORD Bronco?

In the gas tank

What is the Wheel bolt pattern for a ford bronco 1994?


Do you need to remove engine when changing clutch on a Toyota Corolla 1994?

To change the clutch you need to remove the engine, the transmission or both. The clutch is BEWEEN the engine and transmission and you can't get it off without separating them.

How many fuel pumps on a 1994 ford bronco?

only one

What is the horse power on the ford bronco xlt 1994 5.8L?


You are changing the timing belt and you need o know where the timing marks are for the cam shaft and the crankshaft on a 1994 corolla Also how do you align the marks to put engine in time?

You are changing the timing belt and you need o know where the timing marks are for the cam shaft and the crankshaft on a 1994 corolla Also how do you align the marks to put engine in time?

1994 ford bronco keeps dying for no reason?

Check your PCV valve.

Where is the speed sensor on a 1994 Ford Bronco?

Speed sensor is on the rear differential.

What size internal speaker go in a 1994 ford bronco?

The rears are a 6x8.

How do you set the timing on a 1994 ford bronco 5.0?

Maybe computer controlled and not adjustable

How many quarts of oil for a 1994 Ford Bronco 5.8L?

6 Quarts of oil

Bolt pattern on 1994 ford bronco?

All Broncos were a 5 x 5.5"

Why does the engine shake on a 1994 Honda Prelude?

If there's a rough idle, that can be the cause. If whenever you give it some gas the engine looks like a bucking bronco trying to bust out of the chute, then you may have a broken engine mount. make sure you're engine mounts are tight that would cause a lot of vibration try that and see if that works

How do you replace the oil pan in a 1994 ford bronco?

i read it in the haynes manual. you gotta undo the engine mounts, lift the engine like 4 inches or so, put blocks of wood in between the engine mounts and the engine so it doesnt fall and then the pan will clear the crossmember. dont forget to remove the oil pickup bolts.

Dose a 1994 Eddie bower bronco have a rev limiter?

I know that on my 1995 Ford EXPLORER the Powertrain Control Module ( PCM ) will start cutting back on the fuel in order to protect the engine at a certain RPM when it is in gear and a much lower RPM if it is in park or neutral when there is no load on the engine , I assume your Ford Bronco is similar

Starter location on 1994 Altima's Engine?

Where is the starter located on a 1994 altima engine

Study guides

Create a Study Guide