0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Should you glue your toilet closet flange to your pipe?
No, it is not recommended to glue the toilet closet flange to the pipe. The flange should be secured to the floor using bolts or screws, and the toilet is then secured to the flange using wax rings or sealing gaskets. Gluing the flange to the pipe can make it difficult to remove or replace the toilet in the future.
Who invented screw Jack?
Husnain Ali khan invented Screw Jack in 1980 WRONG invented by Leonardo da vinci in 1450 more recent I have worked with screw jacks since 1960
How do you drain hydraulic fluid from a hydraulic floor jack?
Remove screw that lowers jack
What simple machines make up a jack?
a screw
Thread used in screw jack?
acme thread
What is the different with normal flange and flange with jack screw?
Jack Screw is a sistem for dissasembling. The diference is that the flange has threathed holes where a bolt is installed.
Should you glue your toilet closet flange to your pipe?
No, it is not recommended to glue the toilet closet flange to the pipe. The flange should be secured to the floor using bolts or screws, and the toilet is then secured to the flange using wax rings or sealing gaskets. Gluing the flange to the pipe can make it difficult to remove or replace the toilet in the future.
What is manufacturing process for compound screw jack?
Tak up a screw & jack then i will be a screw jack ahahahah
How screw Jack works?
A screw jack is just that, a big screw in a base. As the screw is screwed out, it raises whatever it is under. A scissor jack that is in most new cars uses a screw to pull the jack together which causes it to raise up.
How is the effort applied in the screw jack?
The effort is applied in the screw jack by turning the head of the screw. This then turns the jack a certain amount according to the pitch.
Can you use a screw Jack electrically?
Yes, a screw Jack Can be operated by electrically or manually.
How do you replace a rear transmission seal on a 1985 Toyota pickup auto trans.22r engine.?
I think the standard answer, applies here. Remove the drive shaft. Using a tool, like a screw driver, or anything kinda pointed, and a hammer, pry between the housing and the seal, until you bend the outer flange of the seal enough to grab it with pliers, and twist it out. You can also, drill a small hole, in the flange, and screw in a screw, until the screw is in the flange far enough, that you can grap it with a pair of pliers and yank both of them out.
Do you fill Jack oil into the screw on the side of floor jack?
Take top cover off of jack and there should be a rubber plug or a single screw that you take out to fill jack .
What are the uses in construction for a ball screw jack?
There are several uses for a balll screw jack. Ball screw jack assemblies use small balls to roll between the nut and the lifting ball screw. It creates less friction and increases use life.
How can we design a screw Jack?
why design a screw jack? there are all different types of screw jacks available screw jacks are used on vehicles, other screw jacks are used in construction,and any other lifting application that you can thick of.
Would the filler screw where you engage the jack to go up or down be the filler screw?
No, look on cylinder with jack up.
What is law of screw jack?
A screw jack is an object that is used to lift the car and other heavy objects off the ground.
