Chevy Blazer
Chevy S-10
Chevy Blazer S-10

What is number one on the distriputor on a 1988 Chevy blazer 4.3 v6?

001

Top Answer
User Avatar
Wiki User
Answered
2010-03-18 01:42:21
2010-03-18 01:42:21

Standing in front of the vehicle with the hood open, looking at the distributor, number 1 on the distributor cap would be at the 6 O'Clock position.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


Are the door interchangeable on an 1987 chevy truck and an chevy blazer 1988


Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...



I have a 1987 Chevy Blazer S 10 4X4 2.8l V6 and the timing recommendation is 10 degrees.


we are trying to find regular factory wheels that fit the lug pattern off of a 1997 Chevy blazer s-10 2 wheel drive


The 1988 Chevrolet Blazer front speakers measure three inches by four inches. The rear speakers measure four inches by five inches.


A blown fuse could be the reason the window will not go down on your 1988 Chevy Blazer. Another possibility is that the switch is worn out or has a loose, broken, or corroded wire.


It is out of a 1988 Chevy suburban It is out of a 1988 Chevy suburban


module locatedwhere is the module on a 9 Chevy blazer


do ya have a picture off a chevy s10 blazer fuse box layout



Full size Blazer - 350 - .035 S-10 - 2.5L - .060 - 2.8L - .045 - 4.3L - .035


Located at front driverside fender inside the engine bay


The best option for this is to go to the owner's manuel for your Blazer. If the fuse number is not listed there, contact your closest Auto Parts store.


Antifreeze Needed 2 1/4 Gallons For a 50/50 mix


I haven't done this on my Blazer yet but my manual says to reach up behind the bumper to the light socket, twist it and it will come out of the housing with the bulb so you can change it.


The thermostat is inside the small housing where the top radiator hose connects to the engine block.


This happened with my 2002 Blazer. The windshield wiper switch also had an effect on the radio. The dealership found two weak electrical grounds and that solved the problem.


at a salvage yard & some auto parts stores ----- if you omly have a hole you can get a splice kit at auto zone


Yes you can. It is done all the time. You can buy a after market kit with everything you need to install a v8 in your truck.


This has a vaccum operated servo; you probably have a vaccum line that has come off to the transfer case.


It is important that the spring end of the thermostat is facing into the engine when installed.


Yes it does. standing in the front of the engine it will be bolted on the left side of the TBI / Throttle body injection unit.


Be sure the brightness control switch is not turned off, Check the fuse, Check the bulbs.


no you need one off at least a 1988



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.