0
A slip yoke is when the end of the drive shaft in a RWD vehicle plunges in and out of [most likeley] transmission when rear suspension is flexed.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the difference between a slip yoke and flange yoke on rear of transfer case?
A slip yoke has a splined shaft the drive shaft slides over. This allows the drive shaft to flex on rough terrain. A flange yoke has a flat plate on the transfer case and the end of the drive shaft and they bolt together.
Is the front drive shaft of a 1987 Chevy v10 spring loaded?
NO. It has a slip yoke.
What supports the slip yoke of a one piece drive shaft assembly?
The tailshaft housing and bushing
Where is the drive shaft seal 1996 Chevy Tahoe?
The only seals on the driveshaft itself would be on the slip yoke. You're probably thinking of the pinion seal, which is at the front of the differential, behind the input yoke to the differential.
How do you remove the drive shaft from a 1996 Geo Tracker?
First make drive shaft and yoke to insure tat they are replaced in the same location to maintain factory balance Remove small "U" bolts at yoke Pry drive shaft out of yoke Pull driveshaft off splined end
How do you replace the rear drive-shaft on a 96 tacoma reg cab?
Remove 2 small u-bolts from rear end yoke Pry drive shaft out of yoke Slide front end of drive shaft off front splines
What is the part name for a 1987 Chevy van two piece drive shaft seal that goes between the two shafts under the screw on collar?
slip yoke seal
Replacing front drive shaft On a 1994 Dodge Ram 1500 4x4?
front drive shaft, how do you get the yoke out of the transfore case to replace the ceal?
Why is tranny fluid coming out the yolk in the drive shaft?
The Welsh plug in the yoke is no longer sealed. The yoke will need replaced.The Welsh plug in the yoke is no longer sealed. The yoke will need replaced.
How do you remove a drive shaft on a S10?
Mark driveshaft and yoke to install in same location to maintain factory balance Remove 2 small "U" bolts from rear end yoke Pry driveshaft out of yoke Slide off spline from transmission not all drive shafts are one piece. How you remove the center support bearing(carrier bearing) from the forward drive shaft?
Where can you find a drive shaft yoke for a 2004 dodge ram 1500?
Dealer, salvage yard, Ebay.........
How do you replace the universal joint on a 1997 Dodge Ram 1500 4X4?
Mark position of drive shaft and yoke - to install in the same position (not to upset balance) Remove and discard small "U" bolts on yoke Slide drive shaft up spline end to dislodge drive shaft from yoke. You can either "beat" U join out of shaft, but better to bring to auto parts store that has a machine shop to install new joint Use new "U" bolts to install Make sure "U" joint is fully seated in yoke and installed in same position as removed
