Chevy Celebrity
Chevy Silverado
Chevy 350
Chevy Cavalier Z24

What is specificatons to tightening the rod cap bolts on a 1986 celebrity 2.8 fi?


Top Answer
User Avatar
Wiki User
2005-11-03 06:43:37
2005-11-03 06:43:37

2.8 V6 Engine: Connecting Rod Cap Nuts...37 Ft-lbs Main Bearing Cap Bolts....74 Ft-lbs

User Avatar

Related Questions

To change the alternator in your 1986 Chevrolet Celebrity: 1, Remove the battery ground cable. 2. Unplug remove the wiring from the alternator. 3. Loosen the bolts that hold the alternator in place. Remove the drive belt. 4. Remove the bolts and the alternator will pull out. Reverse the process to reinstall the new alternator.

These are typically easy to changed first take off the pulley then you will have access to the bolts they behind the pulley

The firing order on a 1986 Chevrolet Celebrity V6 is: 1-2-3-4-5-6.

The spark plug gap for a 1986 Chevy Celebrity with the 2.5L 4 cyl engine is .060".

Matlock - 1986 The Celebrity 5-22 was released on: USA: 30 April 1991

It depends slightly on which of the components you are asking about, that is the pump, the rack and pinion or what ever. Please ask again being more specific about the exact bolts you are having trouble loosening or explain what you are trying to change or remove.

I found one source that says a 1986 Chevy Celebrity has a curb weight of 2714 pounds. Different options would change that weight.

the correct torque for these bolts is as follows: 96lbs

Double Dare - 1986 Celebrity Family Double Dare was released on: USA: 5 April 1987

Does your 1986 Chevy Celebrity have the 2.5L 4 cylinder engine or the 2.8L V6?

To remove the steering column in a 1986 Chevy Celebrity: 1. Remove the trim panel under the steering column. 2. Remove the noise panel. 3. If the car has column shift remove the gear indicator from the shift bowl. 4. Unplug electrical connectors. 5. Remove the four bolts that hold the steering column up. 6. At this point the steering column should pull out.

The fuse for the power windows is on the fuse block.

You more than likely have a valve cover gasket leaking. You can try tightening the bolts holding the valve cover in place to 20 lb/ft of torque, (do not over-tighten) and see if that stops the leak. If not, you will have to replace the gasket.

Please clarify your question as in front or rear axle.

On the V6 the ignition module is under the distributor cap.

The 1986 Ford F1 50 pickup truck dashboard is held in place with six retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on the retaining clips.

To change the front blinker bulb on your 1986 Chevy Celebrity simply reach up behind the bumper and unplug the socket from the fixture. Replace the bulb in the socket and plug the socket back into the fixture.

There are 2 bolts that hold the starter in place and 2 nuts that hold the wiring to the solenoid.

The firing order for all years of Chevrolet Celebrity V6's is: 1-2-3-4- 5-6

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.