Oldsmobile Cutlass Supreme

What is theSpark plug gap on Oldsmobile cutlass supreme?

001

Top Answer
User Avatar
Wiki User
Answered
2008-12-30 02:52:56
2008-12-30 02:52:56

what year cutlass? and what engine?

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


The transmission drain plug is actually not located on the 1995 Oldsmobile Cutlass Supreme. This car has a transmission pan that has to be removed rather than a drain plug.


Raise the vehicle and look at the oil pan. You will see a bolt in the oil pan. That is the drain plug.


Bottom of radiator. If it has none then remove the lower radiator hose to drain the radiator.


The 1996 Oldsmobile Cutlass Supreme OBD 2 port is under driver side dash above accelerator pedal


it is located at the front of the engine under the coil packs(where the spark plug wires all connect)


Could be in need of a tune up. Start with replacing the spark plugs and spark plug wires.




My friend didn't put 'em back together right and we need a picture so we can tell how to put the on right. Thank you.



The 1993 Oldsmobile Cutlass 3.1 liter engine spark plug gap is .028. Most spark plugs will come pre-gapped from the manufacturer.


at the junk yard or just take that bull s###t off crimp it or plug it but still run the pump for the belt.




Under the steering wheel to the right


The 1999 Oldsmobile Cutlass OBD 2 port is under driver side dash left of steering column


its not the plug type its the sead beam type take one torqs bit nut loose form thr bulb and the light will come loose


Look at the bottom or rear of radiator Look at the bottom or rear of radiator


The drain plug is no the lower left hand side ( driver side ) of the radiator.


I have a 90 cutlass supreme. Mine has been going goofy for some time now. If it blacks out, flashes off and on, or shows different readings on fuel gauge, odometer or speedometer then you have problem. I took it out and looked for loose plug wires(1 plug) or cicuits. Found none. Needs replaced. Can sometimes be found on Ebay for cheap price. If so make sure it right one!!!


Set the gap at .035 in. for a 115 Mercury.


.054 inch , according to fordparts.com



.044 inch ( according to motorcraft.com )


Firing order on both 2.8 and 3.1 1-2-3-4-5-6 1-3-5 at rear of engine 2-4-6- front of engine



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.