answersLogoWhite

0


Best Answer

4.5 mm but has to be deepwell

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the Bolt size for ignition control module on a 1988 ford ranger?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?

How do you change the ignition control module in a 1988 Chevy Silverado 5.7L


How do you remove the ignition module on a 1988 ford f-250?

how do you remove the ignition control module on a 1988 ford f-250 pickup?


Where is the ignition module located on a 1989 Mazda b2200?

where is the ignition module located on a 1988 Mazda b2200


Where is ignition control module on 1988 dodge van 5.2 v8?

Behind the battery.Behind the battery.


What causes no spark in a 1988 Buick lasabre?

Crank sensor has failed,Ignition control module (ICM) has failed,Bad ignition coil pack,


Does ignition module have any control of fuel pump working?

Yes it does, from the year 1988 through early 1999 models.


Where is the ignition control module located in the 1988 Volvo 240?

Under Dash Passenger side to the right of the kick panel


How do you set the timing on an 1988 Chevy Celebrity?

The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.


Where is the ignition switch module located on the 1988 Cherokee limited?

module locatedwhere is the module on a 9 Chevy blazer


Where is the ignition module on a 1988 Chevy Celebrity 2.5?

The ignition module on a 1988 Chevy Celebrity with 2.5 engine is on the side of the block beneath the intake manifold. You can simply follow the spark plug wires to it. As information the crankshaft position sensor is behind the ignition module.


What happens when the module goes out on the 1988 Chevrolet celebrity?

What happens depends greatly on which module fails. If the engine control module (computer) fails it may cause the engine to run poorly or not at all. If the ignition module fails the engine won't start.


What is the exact location of the ignition control module on a 1988 Ford Festiva?

I'm working on a 1987 Festiva, and I *believe* that this is located inside the distributor housing.