It will cost you approximately $300 to replace the rear main seal on a Jeep Cherokee. The amount will vary slightly depending upon who does the work for you.
you need to replace the vacuum.
A Jeep 4.0L has a two piece rear main seal. You have to remove the oil pan and rear main bearing cap to replace it.
The brake light fuse on a 2003 Jeep Grand Cherokee can be found by looking at the cover to the main fuse box. It identifies each fuse and its location.
If you do it yourself, then it will only be the cost of the seal. If you have it done, then you'll have to call around for an estimate. If you have a manual transmission, then you may consider replacing the clutch and throwout bearing, since you're already there.
The fuse for the fuel pump on a Jeep Grand Cherokee CRD is located in the engine compartment in the main fuse box. It prevents the pump from being overloaded and damaged due to a surge.
The fuel pump relay on a 1992 Jeep Cherokee Laredo is located under the hood. The fuel pump is located under the vehicle and is attached to the main harness.
do all the gages come up (alternator gage, fuel gage ect..) if not replace the main engine computer mine just died goin down the road and i had 2 replace the computer and havent had a problem sunce
Their are 2 main bolts that hold on a thermostat housing for an 1987 jeep cheorkee pioneer!!
The oil pan must be removed along with the rear main bearing cap. The rear main seal is loacated under the rear main bearing cap.
The address of the Cherokee Main Street Program is: 121 East Main Street, Cherokee, OK 73728-0039
spun main bairing
The 1998 Honda Accord main relay switch will cost approximately $125 to replace. You can save $75 by replacing the switch yourself.
I have a 1996 Jeep Grand Cherokee that had the same problem. I found out it was a rod that went from the front right wheel to the main body, it's called a STEERING DAMPENER. After I replaced it she drives like a dream now.
They are 43 Ft. lbs
mains 80 ft lbs rods 33 ft lbs main support brace 35 ft lbs
the thermostat is in the front of the motor wheare the main radator line goes into the motor you need to bleed out the coolant and take off the two bolts after disconecting the hose you then simply take out the old thermostat and gasket and replace with an new one,reassemble
"Main fuse"? Fuses are located in the under hood fuse box."Main fuse"? Fuses are located in the under hood fuse box.
I have done it and its not easy. Please take it to a reputable mechanic the normal guys garage does not have the garage to do the job. you need a variety of pry bars and stuff. Its a complete pain. I will never do it again after finding out it costs like 300 for a mechanic to do it
That's not what is leaking, & you'd have to pull motor to do it. These leak from the oil filter arm or the rear main seal.
Oh, a lot; 4 figures. You have to completely break the engine down to replace a rear main seal.
There isn't a separate computer for just the odometer. Attached to the firewall behind the coolant bottle is the main computer. There are 3 cables that plug into the front of the computer and the odometer is in there. When you buy a new or refurbished computer for your jeep you need the vin number and the odometer reading so the computer can be programmed for your jeep. Meaning the odometer reading is in the main computer
I would imagine you have to pull the tranny and transfer case, Also that part of the exhaust just to access it.