On a Chrysler Sebring 2.5L the thermostat is under the housing where the lower radiator hose hooks to the engine.
what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi
It is the accelerator cable.
engine needs to be removed
I have a 1997 Sebring Convertible. Engine is currently at 152,000 miles and still going strong.
Knowing the firing order of a cars engine is apart of owning a car. The firing order of a 1997 Chrysler Sebring is 1-2-3-4-5-6.
The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
It is on the radiator side of the engine, under the engine mount.
it is inside the engine compartment fuse box.
It is on the front of the engine, behind the motor mount bracket.
Inside the front of the engine, driven by the timing belt.
Yes, the engine computer is the regulator.
A 1997 Sebring does not have a cabin filter.
No, only on the sides.
For a 1997 Sebring Convertible the oil dipstick is located just left of center towards the front of the car and should be labeled "engine".
The factory alarm is built into the body and engine computers and can not be removed.
Have it checked for codes, That is the same as the check engine light.
A Chrysler Sebring does not have a reset switch.
It is behind the engine, after the catalyst.
Chrysler 41 TE
The thermostat is located in the water inlet where the radiator hose connects from the radiator to the engine.
Trouble code P0113 means:Intake air temperature circuit high input
No reset buttons on Chrysler products.
Chrysler does not use reset or inertia switches.
A stereo wiring diagram for a 1997 Chrysler Sebring can be found in its maintenance manual. It can also be found in its repair manual.
The Hydraulic pump for 1997 to 2006 Chrysler Sebring convertible is located behind the back seat and center of the car on a small shelf.
It is under the housing that the lower radiator hose hooks to on the engine.
Add gas, crank engine. If it doesn't start in about 30 seconds, it was not out of gas and you have a different problem.
No, it has a timing belt.
You have to use a scan tool.
It is on the starter.
where is the crank sensor located on my 1997 Chrysler sebring lxi
The spark plug gap for a 1997 Chrysler Sebring is .044 inches. Spark plugs now come preset, however, so manually setting the gap is unnecessary.
It is inside the fuel tank.
It is on the bottom of the reservoir.
I just got a 1997 Sebring convertible and it has 4 seats. I have a friend with a 06 Sebring and it Also has 4
The 1997 Chrysler Sebring transmission is equipped with two transmission mounts. There will be a transmission mount at the back of the transmission, on each side.
when looking from the front of your car into the engine compartment it is to the right of the air filter on the left of the engine fuse box that is below your positive jump start post.
The factory alarm is controlled by the engine and body computers. The engine computer is under the hood and the body computer is under the dash on the back side of the fuse panel.
The air bags might deploy for no reason in a 1997 Chrysler Sebring Convertible if their is a short in the system. It is also possible that a sensor in the bumper was broken somehow.
2.4L On the engine end of the upper rad hose. When replacing it make sure the spring goes toward the engine 2.5L it is under the housing that the lower radiator hose hooks to on the engine.
It doesn't have one.
Unhook the battery for ten minutes.
5w30 conventional or synthetic.
The power steering is not adjustable.