Is there a speed senor for my 1992 nissan 2.4L, wheel drive truck?
According to Champion spark plug applications, the correct gap for 1992 Nissan pickup 2.4L engine is .044
jasper engines and transmission.com
insid ac box at floor board.
Yes, a 1992 Nissan Pathfinder with a V6 engine will bolt up to a 1985 Nissan King Cab 4x4 pickup truck. You just need to purchase an adapter from your local auto/towing store.
My owners manual indicates 15.9 US gallons.
where is the fuel filter located on a 2002 Nissan frontier truck 4 cycle
Yes, it is possible. You would need a donor truck for the parts, as purchasing them new would be very expensive.
I would replace the ignition module in the distributor.
replaceing windshield wipers toyota truck
My 1992 Nissan 240 sx is 038
The 1992 Nissan truck air-conditioner pressure switch is located in the fuse box. The fuse box can be found in the engine compartment.
I have a 85 Nissan truck,2.4,I bought it, (ENGINE) from jasper engines.com,it has a 3 year warranty and 150,000 mile warranty,Ive had it since June,it runs great,I also bought a webbercarb. direct.com,MY TRUCK RUNS BETTER THAN NEW,GOOD LUCK.
screwed into front of transmission.
weak battery or bad alternator.
The 1992 Chevrolet half ton pickup truck has a rated towing capacity of 4500 pounds. The same pickup truck with a camper special option has a towing capacity of 6500 pounds.
all I need to know is the location of the fuel pump relay on a 1992 1500C chevi pickup truck , please
Nope 91 was the last year of that
I have used Pennzoil 10W-30 in my 1987 Nissan Pickup 4 cylinder Z24 for the last 16 years. I bought it in 1992 with 75,000 miles and now have 177,000 miles on it. It uses no oil other than maybe 1/4 or 1/2 quart between oil changes every 3,000 miles. Still seems to be a strong running truck!
how much can a cheve s10 1992 pull ?
The gap should be .040
They are identical except for the 92 uses OBD1 and the 9+ use OBD2 (few more sensors).
The oil pump on a 1992 Nissan Truck cannot get out of time or sync with the engine. It physically locks into position and will constantly pump oil unless the shaft break or becomes detached.
I found the answer out by myself and it is compatible with both the 4 cyl and 6 cyl. Both are 4x4 and 5 speeds.
in back of the alt you can fill it but can not see it take alt out of way to get to it
Per Chilton's, fuel pump is located in the gas tank.
The no 1 spark plug for a 1992 K1500 pickup 5.7 liter engine is the Bosch spark plug. As of 2013, the average price of a Bosch spark plug is $64.99, plus tax and shipping.
The 1992 Chevrolet C 2500 pickup truck has a stated gross weight of 4124 pounds. The gross weight does not include any of the fluids in the pickup truck.
it is probably in the blower motor, at least that is where it is on the 1995 truck. take out glove blox/ remove black metal cover behind glove box. It is the white connector in plain site..
under the dash passenger middle ish
buy ngk platnium. gap is factory preset.
get a haynes repair manual from auto zone or auto parts store,about 25.00.
Well It depends. The engine might be a little different, the the instuments should be the same. Also, a 1990 pickup and a 1992 Pathfinder are pretty much the same in instuments.
Not without fabrication.
A weak spark can be caused by a faulty ignition coil, or perhaps bad spark plug wires.
Look in your owner's manual or under the hood on a placard.
No input voltage to the coil or the coil is bad. Check the distributor for issues and the wires.
There is no drain plug . you will need to remove the trans. pan to drain fluid.
If you turn the ignition to the on position, and then press the interlock button, you don't have to press the clutch pedal down to start the truck.
Yes as long as the truck is not a T100. The 92 and 93 model years were the same as far as the doors are concerned. The only difference you will see is between the 2wd and the 4wd. They had different marker lights in the front.
no it cant be done,they are totally different from each other.
Remove the water supply hoses from your 1992 Chevy S 10 pickup truck heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
Where is the AC sensor located on a 1992 GMC pickup
how do you replace a CV joint on a 1992 Chevy pickup?
One in each of the exhaust manifolds.
You must remove the fuel tank , the fuel pump is located inside the tank.
follow the spark plug wires from the distributer cap to the engine. get to the end, then pull the wire out(gently) and voila! flashlight helps see the plug in da hole.
that depends on the truck if its 2wd short bed then its 13.5 gallons, if its 4x4 or long bed then its 17 gallon tank
not 100% sure but i believe fuel injected