The Anti-Theft code that is associated with the "Theft Deterrent System" is a 5-digit code located on the underside of the ashtray.
what is the anti theft lock code for a 94 acura egend
Remove the Anti-theft system fuse.
take the fuse out
How do you disable the Anti-Theft light in the 1993 ford explorer
Car wont start,anti theft system is activated,
USUALLY REMOVE THE FUSE OR YOU'LL HAVE TO TAKE THE RADIO SER# ( LOCATED UNDER THE ASH TRAY ) TO AN ACURA DEALER AND FOR A SMALL CHARGE THEY CAN LOOK UP THE INFO. THE CODE COMES IN YOUR CAR MANUAL USUALLY ON AN ACURA I.D. CARD ALSO . HOPE THIS HELPS
anti theft will not reset. have tried key, unpluging pin switch, everything i can think of. please help.
The release code is provided in the owner's manual of the vehicle, or on a card provided by Acura. If you don't have it, I expect you'll have to contact the manufacturer.Answerjust go to your local Acura dealer they will give you the code for about $25 bucks then you simply punch it in and that's it, oh but first take out your stereo check in the back for the serial # write it down take it with you there going to ask for it otherwise they charge about $100 to do it. The dealerships charge you an enormous fee instead of telling you, the code is located on the underside of the ashtray!
my steering wheel is locked and key wont turn on my 98 acura tl I think it is the anti theft system How do i disable it so i can start the car
There isn't a single "anti theft" wire. The anti theft system is very complex.
Radio codes of Acura Tl vehicles are part of a standard anti-theft system. To the reset the system just unplug the battery from the car for at least five seconds.
The anti-theft code may be either the code designated for your radio, or the factory (non valet) key. I changed the battery in my 91 legend and the car would start for about 1 second and then shut down. I experienced something similar in a 2000 new beetle. In the beetle it was because the key was not sync'd to the car. With that information I tried my factory equipped key in the ignition, made sure that my radio code was correct and found that it started right up and kept running.